Green Diode-Pumped Solid-State Laser Systems (Hardware)

Recommendations

Info

Specifications Figure A-2 58 PSM 290 Power supply dimensions 30
Appendix B Mounting and OEM Considerations This appendix discusses some specific issues that are of importance to the OEM manufacturer. B1 Mounting Considerations The 58 GLS- and GSS-Series green DPSS lasers are designed to be mounted horizontally, baseplate down, using the black baseplate attached to the bottom of the laser. Mounting the laser in any other orientation is not recommended. If your application requires horizontal plane of polarization instead of a vertical orientation, contact Melles Griot concerning the availability of lasers with the desired polarization orientation. Output beam exit angle is not colinear with mechanical axis. To secure the laser, the baseplate should be mounted on a flat surface (flatness of 0.001”/1”, 32 micro inch surface finish) that extends under the entire baseplate. The baseplate should be retained by four screws (1/4-20 inch or M6) with flat washers. The screws should be tightened to a maximum of 20 lb-in (2.25 Nm). B2 Cooling Considerations For reliable operation, 58 Series green DPSS lasers require an adequate flow of cool air. To ensure proper airflow, there must be a minimum of ½-inch clearance between the air intake and exhaust ports and any obstructing surface. A full inch or more of clearance is preferred. The temperature of the air entering the air intake ports must never exceed 35 o C. Ensure that hot air exhausted from the laseris not recirculated into the air intake at the front of the laser. An optional laser module without integrated heat-sink is available for OEM applications. B3 Compliance Considerations The 58 Series green DPSS laser systems are Class IV or Class 4 laser systems as defined by 21 CFR 1040.10 and EN60825-1:1994, respectively. Although they incorporate many of the features mandated by United <strong>State</strong>s and international regulatory agencies for laser devices, they may not be used as stand-alone laser sources unless an optional CDRH compliance package is purchased. Once the laser is incorporated into another piece of equipment, it becomes the responsibility of the equipment 1 31
Page 1 and 2: Operator’s Manual for Green Diode
Page 3: NOTICE: This manual contains specif
Page 6 and 7: C1 Slope Efficiency................
Page 8 and 9: Introduction to the system or accid
Page 10 and 11: Introduction To designate the contr
Page 12 and 13: For Your Safety technician. There a
Page 14 and 15: For Your Safety • A Guide for Con
Page 16 and 17: Initial Installation • Ensure tha
Page 18 and 19: Initial Installation 11. Disconnect
Page 20 and 21: Operating Your System general, mult
Page 22 and 23: Operating Your System Figure 3-2 La
Page 24 and 25: Operating Your System Main Power (i
Page 26 and 27: Operating Your System Always observ
Page 28 and 29: Operating Your System at least 3 se
Page 30 and 31: Preventive Maintenance 5. Clean win
Page 32 and 33: Preventive Maintenance This page is
Page 34 and 35: Specifications A2 Electrical Specif
Page 38 and 39: Mounting and OEM Considerations man
Page 40 and 41: Mounting and OEM Considerations Fig
Page 42 and 43: Mounting and OEM Considerations 11
Page 44 and 45: Mounting and OEM Considerations C5
Page 46 and 47: Service, Support, and Warranty The
Page 49 and 50: Appendix E Service, Support, and Wa
Page 51: 58 Series Green Diode-Pumped Solid-

Green Diode-Pumped Solid-State Laser Systems (Hardware)

Create successful ePaper yourself

Delete template?

Save as template?