Micronics U1000 Manual Issue 1.pdf - Micronics Ltd.
Micronics U1000 Manual Issue 1.pdf - Micronics Ltd.
Micronics U1000 Manual Issue 1.pdf - Micronics Ltd.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Micronics</strong><br />
<strong>U1000</strong> User <strong>Manual</strong><br />
5 when programming the Zero Cut-off this is limited to the range 0.000 to 0.500. If an invalid<br />
value is entered then the following warning message is displayed.<br />
Range 0.00 – 0.500<br />
0000.0<br />
6 when programming the Calibration Factor this is limited to the range 0.5 to 1.5. If an invalid<br />
value is entered then the following warning message is displayed.<br />
Range 0.500 – 1.500<br />
0000.0<br />
<strong>Issue</strong> 1 Page 24
Change language