Service manual FastMig Pulse power sources version 1.1

More documents

Recommendations

Info

Setup panel card P001 layout SEVEN SEGMENT DISPLAY FOR MEMORY CHANNELS PULSE POTENTIOMETER FLATCABLE CONNECTOR JTAG CONNECTOR MEMBRANE PANEL CONNECTOR LCD DISPLAY MICROPROCESSOR JUMPER CONNECTOR (FOR FUTURE PURPOSES)
Setup panel card P001 connectors PF65 (X1) and P65 (X1) CAN bus interfaces are identical. Both Panels use CAN interface and KeBus protocol. Connector/pin X1/1 X1/2 X1/3 X11/4 X1/5 X1/6 X1/7 X1/8 X1/9 X1/10 X1/11 X1/12 X1/13 X1/14 X1/15 X1/16 Connector type Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Description Not connected Not connected Not connected Not connected WF number CAN transfer GND CAN receive Not connected Not connected Not connected Not connected Not connected Not connected +5VDC GND When panel starts panel software <strong>version</strong> number in in display, during this period of any of the buttons are pressed, all memory channel segments turn on and all LCD pixels are also turned on. This function can be used to test the panel buttons and LEDs/displays. This test mode is only possible when panel is starting
Page 1 and 2: Service manual FastMig Pulse power
Page 3 and 4: Electrostatic Discharge Electrostat
Page 5 and 6: General service procedure It is rec
Page 7 and 8: Safety test Insulation resistance m
Page 9 and 10: General troubleshooting Always try
Page 11 and 12: Diode tests Use multimeter with dio
Page 13 and 14: IGBT tests IGBT gate lead testing (
Page 15 and 16: IGBT tests Kemppi IGBT testing by K
Page 17 and 18: Low voltage test Low voltage test g
Page 19 and 20: Gate driver card A001 layout POWER
Page 21 and 22: Gate driver card A001 connectors Co
Page 23 and 24: Processor card A002 layout PRIMARY
Page 25: Processor card A002 connectors Conn
Page 29 and 30: Main circuit card Z001 connectors C
Page 31 and 32: Secondary rectifier card Z003 layou
Page 33 and 34: Load bank test Load back test is us
Page 35 and 36: Load bank test To make MIG/MAG load
Page 37 and 38: Construction, right side PRIMARY CH

Service manual FastMig Pulse power sources version 1.1

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?