here - Snap-on Equipment

<strong>Snap</strong>-on EEWB300A Operators Manual
8.6 STOP-ON-TOP CALIBRATION
No calibration is required for this feature.
The balancer is equipped with an exclusive program that selfcalibrates
the balancer automatically during use.
The Stop-on top is not effective on wheels with rims smaller
that 13”.
Heavy wheels will not stop exactly on top but close to the top
dead center, because of the inertia.
8.7 SELF-DIAGNOSTIC PROGRAM
During the working cycle of the wheel balancer the
microprocessor can display some errors which are shown
as follows:
Err 1 :
balancing cycle interrupted with the STOP button.
Err 4 :
the wheel did not reach the balancing speed.
Err 6 :
no spin before tire matching.
9.0 MAINTENANCE
Fig.62
70
BEFORE ANY MAINTENANCE OR RE-
PAIRS ARE ATTEMPTED THE MA-
CHINE MUST BE DISCONNECTED
FROM THE ELECTRIC SUPPLY.
This balancer does not require any special maintenance, but
the following precautions are required:
11.0 PUTTING THE MACHINE OUT OF SERVICE
In case the machine is not to be used for a long period of
time (6 months or more) it is necessary to disconnect all power
sources and protect all parts that may be damaged.
When putting the machine back in operation, check first the
condition of all previously protected parts, and check for correct
functioning of all devices before using the machine again.
A. Periodically wash all plastic parts with a glass cleaner.
Wipe with a dry cloth.
B. Clean all adapters regularly with a non-flammable liquid
detergent all adaptors. Lubricate with a thin layer of oil.
10.0 MOVING THE MACHINE
In case the machine is to be moved from one area to another,
proceed as follows:
Disconnect the machine from the electric supply.
Remove all objects that may fall during the relocation and
create a hazard.
Do not use metal ropes to lift the machine.
Slide the machine on the forks of a forklift.
Hold the machine as depicted in Fig. 62.
Page 20