P350 MANUAL 1.cdr - Harmar
P350 MANUAL 1.cdr - Harmar
P350 MANUAL 1.cdr - Harmar
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
INSTALLATION & ASSEMBLY<br />
6<br />
Attach Seat Support Frame<br />
RIGHT<br />
HAND<br />
FLANGE<br />
BEARING<br />
(x2)<br />
LEFT<br />
HAND<br />
The <strong>P350</strong> has ambidextrous seating which<br />
allows the seat to be set to face either side<br />
of the pool dependant on pool installion<br />
and/or preference, shown to the left.<br />
SEAT SUPPORT<br />
FRAME<br />
Once chosen, grease the surfaces<br />
of the Flange Bearings and the Seat<br />
Support Frame, if necessary, as shown<br />
in the picture. Insert the Flange Bearings<br />
into the Arm and insert the Seat Support<br />
Frame into the bearings, below.<br />
RIGHT<br />
HAND<br />
ADD<br />
GREASE<br />
ARM & BASE<br />
ASSEMBLY<br />
INSERT INSERT<br />
7 Link Shaft Adjustment<br />
The Link shaft should be attached and fastened on<br />
the opposite side of the Seat Support Frame. If this<br />
is not the case, then simple unfasten the Link Shaft<br />
and attach it onto the otherside of the base.<br />
3/8-16<br />
NYLON<br />
NUT<br />
LINK<br />
SHAFT<br />
BASE<br />
3/8<br />
NYLON<br />
WASHER<br />
3/8-16 x 1.50<br />
SOCKET<br />
HEAD<br />
8 Attach Rotation Plate<br />
1/2-13<br />
NYLON<br />
NUT<br />
3/8-24 x 1<br />
BUTTON<br />
HEAD W/<br />
NYLON<br />
PATCH<br />
Rotate the Rotation Plate forward and<br />
fasten to Seat Support Frame with the<br />
appropriate fasteners.<br />
ROTATION<br />
PLATE<br />
SPRING<br />
LOCK<br />
WASHER<br />
14