P350 MANUAL 1.cdr - Harmar
P350 MANUAL 1.cdr - Harmar
P350 MANUAL 1.cdr - Harmar
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PRE-INSTALLATION<br />
POOL DECK REQUIREMENTS<br />
Fig 2: Minimum Deck Requirements<br />
Fig 3: Lift Location and Hole Specifications<br />
Minimum Deck Requirement:<br />
Minimum concrete slab should be at least 60” x 42” x 4.00” thick, reinforced<br />
(#4 rebar) with a concrete strength of 3000PSI.<br />
Anchors must be installed a minimum of 4” or greater from the edge of the slab<br />
Existing slab does not exhibit any signs of cracking or deterioration.<br />
For proper installation into an existing deck, follow these guidelines.<br />
1<br />
2<br />
To determine the proper area to install the lift, follow the ADA guidelines, Fig. 1.<br />
Verify that the pool deck meets the minimum requirements above, also see Fig.2. If the deck does not<br />
meet these requirements, then the deck needs to be cut and replaced with a new slab that meet these<br />
requirements. The new slab needs to be reinforced with rebar and adhered with epoxy into the<br />
remaining existing deck. Simpson SET epoxy is recommended or equivalent for installation.<br />
!<br />
WARNING<br />
When operating equipment, operator should ALWAYS wear<br />
Personal Protective Equipment<br />
8