15-B Operation (Mach Ctr), GFZ-62564E-1/02

1. INTRODUCTION
B–62564E–1/02
3) Automatic operation
(i) Program selection
Select the program used for the workpiece. Ordinarily, one program is prepared for one workpiece.
If two or more programs are in memory, select the program to be used, by searching the program number
(See 5.2.1).
Fig. 1 (f)
Program Selection for Automatic Operation
(ii) Start and stop (See Section 5.3 to 5.5)
Pressing the cycle start pushbutton causes automatic operation to start. By pressing the feed hold
or reset pushbutton, automatic operation pauses or stops. By specifying the program stop or program
termination command in the program, the running will stop during automatic operation. When one process
machining is completed, automatic operation stops.
Fig. 1 (g)
Start and Stop for Automatic Operation
– 6 –