15-B Operation (Mach Ctr), GFZ-62564E-1/02

1. INTRODUCTION
B–62564E–1/02
ii) Displaying and setting parameters (10.6)
The CNC functions have versatility in order to take action in characteristics of various machines. For
example, CNC can specify the following:
a) Rapid traverse rate of each axis
b) Whether the position is detected with digital or analog data
Whether reference position return is based on the grid or analog system
The data determining these items are called parameters (see Section 10.5).
The parameters are specific to the machine.
Fig. 1 (q)
Parameter Display/Setting
iii) Displaying and specifying data (see Section 10.3).
⋅
⋅
⋅
In addition to the parameters, settings for changing the attributes of the machine are provided. The
operator can set these items if necessary while the machine is operating.
For example, the following settings are provided:
(1) Settings for the area the tool must not approach (stroke check)
(2) Settings for I/O devices
(3) Amount of return and minimum depth of cut in the canned cycle
– 12 –