Introduction - sensitec

More documents

Recommendations

Info

Control Monitor CoMo Net ® Type 5863A The [System setup] page shows all settings which are independent of the parameter sets. 5.2 Setting Application y(x) You should normally choose this operating mode. This will give you more accurate measurements, since the speed of the machine has no influence on the measurements. 5.3 Setting Application y(t) If the machine does not supply a displacement (or angle) signal, you need this operating mode. Some facilities are thereby restricted such as x-real-time thresholds. 5.4 Changing the Set Values of an Application Please note the following: • Switching y(x) y(t): statistical and trend data as well as real-time thresholds and evaluation objects will be deleted. • Changing evaluation objects (EO) will delete statistical and trend data Page 34 002-228e-08.03 (B10.5863Ae)
Applications 5.5 Measuring Mode The CoMo Net supports two measuring modes: manual and automatic (normally used). In the manual mode, start and end of measurement are defined by the user pressing the appropriate button (see 6.4.4). In the automatic mode, the measurement is controlled by the control system (e.g. SPC): via digital I/O or the field bus. Some operations on the ‘Measure’ page are possible only under certain conditions (see table). Operation Manual Automatic Supervisor only Select Manual/Automatic X X X Start/Stop Manual Measurement X Previous/Next Cycle X Zoom Setting/Off X X Reset Statistics/Trend X X Select Parameter Set X X X 5.6 Specifying Start and End of Measurement You have several possibilities for signaling the beginning and end of measurement to the CoMo Net. The easiest possibility is with the start and stop signal at digital input 1 (from a switch or from the SPC). It is also possible to set the CoMo Net initially to measurement readiness and to start the actual measurement with an additional signal at digital input 2. See sections 6.7.8, 6.7.9 and 6.9.7. 5.7 Evaluation Object Positioning Position the evaluation objects (EO) so that the curve is produced with as few objects as possible, but enabling errors in your process to be clearly detected, at the same time ensuring that very minor errors do not cause a cycle to be evaluated as bad. Note the facility for evaluating in the forward direction and the relative EOs. See section 6.8. 002-228e-08.03 (B10.5863Ae) Page 35
Page 1: Operating Instructions Control Moni
Page 4 and 5: Control Monitor CoMo Net ® Type 58
Page 86 and 87:
Control Monitor CoMo Net ® Type 58
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138:
show all

Introduction - sensitec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?