KDR – CaRTon LIvE SToRaGE SySTEM - SSI Schäfer

KDR Carton Live Storage
Combinations of fl ow bed arrangements
Rear profile
Central/inner support
Chute profile
Front profile
Rear profile K-QH
With wide lower edge for
track support
Rear profile K-QH-KLT
With lengthened upper edge;
this ensures that the KLT
container on the track does
not become jammed
Angled profile K-QK
For use with automatic
loading e.g. with RBG; no
locking device
Central cross support K-QM
In the case of flow beds of
over 3,100 mm in length,
this profile section – used in
conjunction with fixing clips –
can provide extra stability for
the roller track and guides;
can also be used to support
the discharge plate in the
case of high loads and
great depths
Chute profile K-QK
For use on outlet chute; for
attaching track and guides to
outlet chutes
Profile reinforcer K-QKV
This profile section can be
used to provide extra
reinforcement for wider,
heavily loaded flow beds
Front cross connector K-QV
W+ith end-stop
Front profile for pick-by-light
K-QV-PBL
For attachment of a
pick-by-light indicator; this
profile can be supplied in
three angled settings
Front profile K-QV
This profile with end-stop
edge can also be attached
at the rear
Internal cross support K-QI
Support for roller tracks; the
load capacity of the flow bed
is determined by the number
of cross supports
Cross profile step K-QT
Built in step on picking side;
the side profile must be
extended correspondingly to
suit; for added safety, the
bed side profile must be
bolted to the upright
Cross profile step K-QT
Built in step on loading
side; the side profile must
be extended correspondingly
to suit; for added safety, the
bed side profile must
be bolted to the upright
22