Sound - Dynacord MP7-Manual - SXS Events
Sound - Dynacord MP7-Manual - SXS Events
Sound - Dynacord MP7-Manual - SXS Events
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
STANDARD INSTALLATION<br />
ent production courtesy Phone: of and Audio-Visual 0870 080 2342 Services<br />
www.sxsevents.co.uk<br />
email: enquiries@sxsevents.co.uk<br />
— Place the needed sound source devices (e.g. CD-Player, turntable) or microphones on a secure even location<br />
and, if necessary, establish mains connections<br />
— Connect all the gear to the <strong>MP7</strong> (Fig. 2).<br />
(Fig. 2)<br />
— Employ cables with stereo phone-type plugs to connect the AM12 to the MONO OUT of the <strong>MP7</strong>. Set the<br />
LINE IN-control on the AM12 at its center position. This lets you control the AM12’s volume setting from the<br />
MONO OUT-control on the <strong>MP7</strong>.<br />
— Set all faders on the <strong>MP7</strong> at their minimum position and turn all output controls (e.g. MONO OUT)<br />
counterclockwise as far as possible. Switch on the power of all included components in the following sequence:<br />
1. <strong>Sound</strong> source equipment, e.g. CD-Player, turntable, etc.<br />
2. <strong>MP7</strong><br />
3. AM12 active monitors<br />
Following this order when switching on your system prevents unpleasant power-on noise and feedback.<br />
— Your PA-system is now ready for operation!<br />
www.sxsevents.co.uk<br />
42
Change language