MDR Technical Handbook.pdf - Omni Metalcraft Corp.

More documents

Recommendations

Info

MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOK PRE-START-UP OVERVIEW: PREPARING FOR INITIAL START-UP 1) Review pages 7 and 8 prior to starting any equipment. 2) Verify that conveyor sections, leg supports, etc. were installed properly. 3) Verify that all zone-to-zone cabling is connected properly. 4) Verify that all sensor cabling is connected properly. 5) Verify that conveyor is not loaded with product. 6) Verify drive rollers are securely bolted to side frame. 7) Verify all slave rollers are attached to drive roller with proper drive bands. 8) Check all drive rollers, photo-eyes and drive modules for proper wiring. 9) Check all drive module DIP switch settings. (DIP switches must be set before supplying power to drive modules) <strong>MDR</strong> TECHNICAL HANDBOOK 2011.1 18
MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOK MAINTENANCE: MAINTENANCE SCHEDULES Note: Review pages 9 and 10 prior to performing maintenance on any equipment. WEEKLY MAINTENANCE Unit Safety Check Confirm placement of all warning labels. Check for loose bolts, unrestrained wiring, loose wiring connectors, nip points and other hazards. MONTHLY MAINTENANCE Belt Tension Check for consistent belt tension between rollers and replace belts as needed. QUARTERLY MAINTENANCE Drive Rollers Ensure that drive roller is operating within its proper heat and noise range. <strong>MDR</strong> TECHNICAL HANDBOOK 2011.1 19
Page 1 and 2: MDR TECHNICAL HANDBOOK 2011.1 MDR T
Page 3 and 4: MOTOR DRIVEN ROLLER CONVEYOR STRAIG
Page 17: MOTOR DRIVEN ROLLER CONVEYOR STRAIG

MDR Technical Handbook.pdf - Omni Metalcraft Corp.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?