BigIR-Mark-IV-Manual.. - SteppIR

More documents

Recommendations

Info

Element Housing Unit (EHU) Wiring Instructions Refer to page 24-25 for 2112 116TH AVE NE SUITE 1-5, BELLEVUE WA, 98004 WWW.STEPPIR.COM TEL: (425)-453-1910 FAX: (425)-462-4415 10
BigIR Mark IV Reinforcing Plate Installation NOTE: The new BigIR Mark IV vertical model was introduced in November 2011. All BigIR vertical antennas are now made to the specifications of the Mark IV. This next section describes how to install the reinforcing kit for your BigIR vertical. The pictures below show the completed reinforcing kit installation. BigIR Wind Reinforcing Kit without 80m coil BigIR Wind Reinforcing Kit with 80m coil 2112 116TH AVE NE SUITE 1-5, BELLEVUE WA, 98004 WWW.STEPPIR.COM TEL: (425)-453-1910 FAX: (425)-462-4415 11
Page 1 and 2: BigIR - MK IV Vertical - Instructio
Page 3 and 4: SteppIR - Why Compromise? The Stepp
Page 5 and 6: Installing the BigIR Extension Tube
Page 7 and 8: BigIR EST Extension Tube Instructio
Page 9: Attaching the Telescoping Pole to t
Page 13 and 14: Wind reinforcing kit installation i
Page 15 and 16: Wind reinforcing kit installation i
Page 17 and 18: Recommended Radials Figure 43 Groun
Page 19 and 20: All vertical monopoles need some fo
Page 21 and 22: Relative Gain Sufficient Radial Len
Page 23 and 24: Can’t get enough droop angle to a
Page 25 and 26: Wiring Diagram- DB25 Cable Splice 2
Page 27: 2112 116TH AVE NE SUITE 1-5, BELLEV

BigIR-Mark-IV-Manual.. - SteppIR

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?