SY250F General Service - Scorpa

More documents

Recommendations

Info

<strong>General</strong> informations WARNING • The carburettor is a part of the fuel line. Therefore, be sure to install it in a wellventilated area, away from flammable objects and any sources of fire. • Never look into the carburettor intake. Flames may shoot out from the pipe if the engine back-fires while it is being started. Gasoline may be discharged from the accelerator pump nozzle when the carburettor has been removed. - The carburettor is extremely sensitive to foreign matter (dirt, sand, water, etc.) During installation, do not allow foreign matter to get into the carburettor. - Always handle the carburettor and its components carefully. Even slight scratches, bends or damage to carburettor parts may prevent the carburettor from functioning correctly. Carefully perform all servicing with the appropriate tools and without applying excessive force. - When the engine is stopped or when riding at no load, do not open and close the throttle unnecessarily. Otherwise, too much fuel may be discharged, starting may become difficult or the engine may not run well. - After installing the carburettor, check that the throttle operates correctly and opens and closes smoothly. 60
Effects of the setting parts on the throttle valve opening <strong>General</strong> informations Fully open Closed 1 3/4 1/2 1/4 0 Valve throttle Pilot screw Main screw Jet needle Pilot system The FLATCR carburettor is manufactured with a pilot screw. The pilot screw adjustment rangdes from fully closed throttle (don’t tighten) to 3 turn open throttle. 61
Page 1 and 2:
General informations General inform
Page 3 and 4:
SUMMARY General informations 1 SECU
Page 5 and 6:
General informations 6.8 WHEEL-AXLE
Page 7 and 8:
General informations 8 CARE AND STO
Page 9 and 10: General informations 2 DESCRIPTION
Page 11 and 12: General informations 2.3 Left side
Page 13 and 14: General informations 3 CONTROLS AND
Page 15 and 16: General informations • Indication
Page 17 and 18: General informations 3.1.5 Clutch l
Page 19 and 20: General informations 3.1.7 Front br
Page 21 and 22: General informations Precautions in
Page 23 and 24: General informations Locking the di
Page 25 and 26: General informations To remove the
Page 27 and 28: General informations 3.2.3 Fuel tap
Page 29 and 30: 3.3 Side stand General informations
Page 31 and 32: 4.1 Check points before use General
Page 33 and 34: tyres • Check of the depth of the
Page 35 and 36: General informations 5 INSTRUCTIONS
Page 37 and 38: General informations 3. Spread the
Page 39 and 40: General informations 5.4 Fuel consu
Page 41 and 42: General informations 5.6 Parking Wh
Page 43 and 44: General informations 6.1 Tools In m
Page 45 and 46: Timing chain sprockets, timing chai
Page 47 and 48: Brakes • Adjust lever position an
Page 49 and 50: 49 General informations Front fork
Page 51 and 52: General informations 6.3 Spark plug
Page 53 and 54: General informations 2. Clean the j
Page 55 and 56: General informations Max level Min
Page 57 and 58: General informations 6.5 Air filter
Page 59: General informations 6.6.1 Tuning e
Page 63 and 64: 63 General informations Main screw
Page 65 and 66: 6.8 Wheel-axle units General inform
Page 67 and 68: General informations 8. Tighten the
Page 69 and 70: 6.9.2 Pieces of information about t
Page 71 and 72: General informations 6.11 Transmiss
Page 73 and 74: General informations WARNING: if th
Page 75 and 76: 6.12.2 Adjustment of handlebar You
Page 77 and 78: General informations 6.13 Adjustmen
Page 79 and 80: General informations The front brak
Page 81 and 82: General informations 6.14.3 Pad wea
Page 83 and 84: General informations MAX MIN MIN
Page 85 and 86: General informations Lubricating In
Page 87 and 88: General informations WARNING If the
Page 89 and 90: General informations 6.18 Rear susp
Page 91 and 92: General informations The bike is ma
Page 93 and 94: General informations WARNING : if t
Page 95 and 96: General informations WARNING: • T
Page 97 and 98: General informations If any importa
Page 99 and 100: General informations 6.21.2 Compres
Page 101 and 102: General informations 7 Put in confo
Page 103 and 104: General informations Install the up
Page 105 and 106: 7.3 Install the electrical wiring G
Page 107 and 108: General informations - Put the head
Page 109 and 110: General informations - Install the
Page 111 and 112:
General informations - Fix the dire
Page 113 and 114:
General informations 8.1.2 Cleaning
Page 115:
General informations • Clean the
show all

SY250F General Service - Scorpa

Create successful ePaper yourself

Delete template?

Save as template?