SY250F General Service - Scorpa
SY250F General Service - Scorpa
SY250F General Service - Scorpa
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6.8 Wheel-axle units<br />
<strong>General</strong> informations<br />
6.8.1 Front wheel removal<br />
1. Loosen the front wheel-axle and the screws on the bottom of the front fork arms.<br />
2. Lift the front wheel, by using a raising stand or by putting a jack under the engine<br />
protection. Take care the bike is stalled enough to prevent it from overturning.<br />
3. Remove successively the axle and the wheel.<br />
6.8.2 Front wheel fitting<br />
1. Lift the wheel up within the two front fork arms, and make sure the brake disk is<br />
situated within the brake pads.<br />
2. Thread the wheel axle through the two front fork arms, the speedometer<br />
mechanism, and the wheel hub.<br />
3. Tighten the axle to the recommended torque: 30 Nm (3,0 m.Kgf).<br />
4. Tighten the screws on the bottom of the front fork arms.<br />
6.8.3 Rear wheel removal<br />
1. Loosen the wheel axle nut.<br />
2. Turn the two chain tension eccentrics in the direction which allows the wheel to<br />
move towards the front of the bike.<br />
65