Thermal Solutions Boiler Controller To Building Automatio
Thermal Solutions Boiler Controller To Building Automatio
Thermal Solutions Boiler Controller To Building Automatio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Thermal</strong> <strong>Solutions</strong> ProtoNode Start Up guide Page 12 of 32<br />
3.3 Wiring the ProtoNode RER to RS-485 Field Protocol<br />
<br />
<br />
<br />
Connection from ProtoNode RER to BACnet MS/TP and Metasys N2 networks<br />
See Section 4 for information on connecting the ProtoNode RER to a BACnet/IP network.<br />
The Field Protocol can be connected to the 3-pin connector on ProtoNode RER as shown.<br />
ProtoNode Pin # Pin assignment<br />
Pin 1 RS-485 +<br />
Pin 2 RS-485 -<br />
Pin 3<br />
RS-485 GND<br />
Figure 5: Connection from ProtoNode to RS-485 Field Protocol –BACnet MS/TP or Metasys N2<br />
<br />
If the ProtoNode is the last device on the RS-485 trunk, then enable the End-of-line termination needs to be<br />
enabled. The default is off.<br />
End-of-Line Switch<br />
0<br />
Figure 6: End-of-line termination on from ProtoNode to RS-485 Field Protocol – BACnet MS/TP or Metasys N2.<br />
ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com<br />
Tel: (408) 964 4444 Fax: (408) 964 4425 <strong>To</strong>ll Free: (800) 317 8319 x141 email: support@protocessor.com
Change language