Download - Schenck AccuRate

Q. Why doesn’t the system totalize or show a feed rate?A. The systemmust be running or integrating. This is shown by thedot turning in the upper left corner of the display.Q. What rate should be displayed on the unit when the test weights areon the scale?A. Check your design sheet.Q. Why does the system not run after powering up?A. The default condition for a power failure alarm is A. This mustbe cleared from the display by pressing the Ack. Alarm button. Ifyou want to change the default condition for a power failure,you can change parameter O01 to Ignore. Follow the stepsbelow to change O01.1. Press the Function button.2. Press the Scroll button until the lower display showsProgramming.3. Press the Enter button.4. Press the Scroll button until the lower display shows EnterParameters.5. Press the Enter button.6. If prompted, enter the password 07734 and press the Enterbutton.7. Press the Scroll button until the lower display shows Block: O.8. Press the Enter button.9. Press the Scroll button until the lower display shows O01.10. Press the Edit button.11. Press the Scroll button until the lower display shows Ignore.12. Press the Enter button.13. Press the Escape button twice.Q. Why are the Tare and Weight Check programs taking so long?A. You must run the Impulses/Belt Circuit program before runningTare and Weight Check.Q. Why is the system displaying negative feed rate?A. Load cells may be wired backwards. Check the over load stops.Q. What is the symbol displayed in the upper left corner of the display?A. This means you are in a special mode of operation, such asVOL, keyboard, simulation, or batch.Q. Why is the system not starting?A. All alarms must be acknowledged by pressing the ACK. Alarmbutton before the system will run. See the following questions onstarting from various sources.18 BV-H5058GB / 0851 INTECONT® MS Commissioning and Set-Up SCHENCK AccuRate