Accusys InneRAID Slim SATA User Manual

More documents

Recommendations

Info

User’s Manual4. Management4.1. StorConn GUI introductionInneRAID ® Slim supports remote RAID subsystem monitoring by web-based GUI. This sectioncovers the introduction of the monitoring software.StorConn monitoring program, aKey Featuresweb-based GUI supporting In-band• Graphical User Interface (GUI)• Multi-interface supportinterface via SATA channel and• Remote monitoringOut-band interface via RS-232, by• Web-based environmentwhich customers can monitor the RAID• Event notificationstatus from web browsers at a remotesite of LAN (Local Area Network). The StorConn is also capable of sending out notification mailto the customers.4.1.1. RAID status monitoring window1. RAID controller tab: Allows customer to select which RAID that connected to local hostsystem both through out-band and in-band to monitor.2. Controller information: Lists model name, serial number and current RAID level.3. Disk status: Allows customer to monitor the status of each disk drive.4. Disk information: Lists model name and capacity of each disk drive.5. Re-build / initialize progress: Tracks the re-building or initialization process.http://www.accusys.com.tw 15
User’s Manual5. Update FirmwareInneRAID ® Slim allows updating firmware via RS-232 interface. The firmware can be updatedfrom a host PC with third party communication software, such as HyperTerminal, that supportsANSI terminal emulation. The setup process for HyperTerminal will be guided in this chapter.NoteThe data and configurations on the array are not affected byfirmware updating.NoteThe HyperTerminal is bundled as standard with MicrosoftWindows operating system. It will be found in theCommunications folder. The program can also be downloadfrom Higraeve Software at http://www.higraeve.com/htpr/5.1. Firmware updating steps1. Ensure your InneRAID ® Slim is turned off.2. Connect one end of the supplied RS-232 cable to the RS-232 3pin port from the Pin1,2,3 ofthe J10 on your InneRAID ® Slim, and connect the other end to one of the host computer’sCOM port.| Pin1 to A | Pin2 to B | Pin3 to C |3. Launch HyperTerminal from the host computer: Start > Programs > Accessories >Communications > HyperTerminal.4. Select COM1 or COM2 from the Connect using: dropdown menu, depending on which porthttp://www.accusys.com.tw 16
Page 1 and 2: Accusys InneRAID ® Slim SATAUser M
Page 3 and 4: User’s ManualPrefaceNoticeProduct
Page 5 and 6: User’s Manual1. Introduction to t
Page 7 and 8: 1.3. Understanding RAID LevelUser
Page 9 and 10: User’s Manual5. Standard AT/ATX D
Page 11 and 12: User’s Manual| Pin1 to A | Pin2 t
Page 13 and 14: User’s Manual3.2.2. Application 2
Page 15: User’s Manual(Figure 3.4.1.B)6. T
Page 19 and 20: User’s Manualdownload code (Firmw
Page 21 and 22: User’s Manual7. Contact AccusysAc

Accusys InneRAID Slim SATA User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?