ASC 907 - Code7700

AIRCRAFT SERVICE CHANGENUMBER 907SUBJECTINDICATING / RECORDING (ATA 31)PLANEVIEW ® MASTER OPERATING SYSTEMSOFTWARE UPDATE (SV-PFD)September 8, 2008

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"PILOTS INFORMATION SHEETPLANEVIEW MASTER OPERATING SYSTEMSOFTWARE UPDATE (SV-PFD)This service change installs the PlaneView Master Operating System (MOS) softwareEB7031236-00411 on G450 aircraft.Aircraft operating under FAA regulations will require FAA Airplane Flight Manual (AFM)Revision 19, or later approved version, as a result of this service change.Aircraft operating under EASA / JAA regulations will require JAA Airplane Flight Manual(AFM) Revision 8, or later approved version, as a result of this service change.PLEASE DETACH AND GIVE TO FLIGHT DEPARTMENT PERSONNELAircraft Service Change prepared by Gulfstream Aerospace, Savannah International Airport, PO Box 2206, SavannahGeorgia, 31402-2206, USA. © 2008, Gulfstream Aerospace. All rights reserved, including the right to reproduce thispublication. No part may be reproduced, stored in any retrieval system or transmitted in any part or form or by anymeans electronic, photocopying, microfilm, microfiche, mechanical or otherwise, without prior written permission ofGulfstream Aerospace.This technical data is controlled under the Export Administration Regulations by General License TSU. It may not betransferred to a third party without the prior written approval of the U.S. Department of Commerce.

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"PILOTS INFORMATION SHEETPLANEVIEW MASTER OPERATING SYSTEMSOFTWARE UPDATE (SV-PFD)This service change installs the PlaneView Master Operating System (MOS) softwareEB7031236-00411 on G450 aircraft.Aircraft operating under FAA regulations will require FAA Airplane Flight Manual (AFM)Revision 19, or later approved version, as a result of this service change.Aircraft operating under EASA / JAA regulations will require JAA Airplane Flight Manual(AFM) Revision 8, or later approved version, as a result of this service change.PLEASE RETAIN THIS COPY WITH THE ASC BOOKLETAircraft Service Change prepared by Gulfstream Aerospace, Savannah International Airport, PO Box 2206, SavannahGeorgia, 31402-2206, USA. © 2008, Gulfstream Aerospace. All rights reserved, including the right to reproduce thispublication. No part may be reproduced, stored in any retrieval system or transmitted in any part or form or by anymeans electronic, photocopying, microfilm, microfiche, mechanical or otherwise, without prior written permission ofGulfstream Aerospace.This technical data is controlled under the Export Administration Regulations by General License TSU. It may not betransferred to a third party without the prior written approval of the U.S. Department of Commerce.

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"The design change effected by this Aircraft Service Change (ASC) has been classified asLevel 1 Major. This modification is approved and accepted by:• The United States Federal Aviation Administration (FAA) – Project Number ODA-T-2008-GIVX-SA-010• The European Aviation Safety Agency (EASA) – Project Number - EASA.IM.A.C.01865The design of this ASC is approved by aircraft type design data for installation on aircraftregistered for operation in accordance with applicable regulations of the FAA and EASA.The design of an ASC is configured to a standard (“greenie”) production aircraft. If sparewires, pin connections or locations called out have been used for another modification, theinstalling agency must ensure the development, documentation and approval of any requireddeviations.The following instructions, in step-by-step form, are written as a guide to perform this ASC.Compliance with safe maintenance practices, as defined in the Aircraft Maintenance Manualand FAA or EASA regulations, is required. It is the responsibility of the installing facility toread all instructions contained in this service change and refer to all associated documents,drawings and manuals for applicable actions.Gulfstream considers this ASC a means to enhance aircraft capabilities to meet individualoperator requirements. The modification is not related to any safety or airworthinesscondition.Subject:Indicating / Recording Systems (ATA 31) – PlaneViewMaster Operating System Software Update (SV-PFD)Purpose / Discussion:This service change installs the PlaneView MasterOperating System (MOS) software EB7031236-00411on G450 aircraft.The new master operating software provides theplatform required for the installation and operation ofSynthetic Vision – Primary Flight Display (SV-PFD)function.NOTE:All In-Service Evaluation participants must comply with this service changeas published.Description / Man-HoursRequired Per Aircraft:This service change installs updated Master OperatingSystem software, PN EB7031236-00411.Approximately 10 man-hours will be required for thisinstallation.Page 1 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"Approved Engineering Data:The source data for this aircraft service change is:1159ASC47907 Rev. “A”, Top Drawing – MasterOperating System (MOS) Update SV-PFDPrerequisites:G450 ASC 023 – PlaneView Avionics Enhancement,Certification DeltaG450 ASC 906 – PlaneView Master Operating SystemSoftware UpdateSubmit APM Settings & Riggings formConcurrent Requirements:G450 ASC 052 - PlaneView Avionics Enhancement (SV-PFD) and ASC 037 Synthetic Vision – Primary FlightDisplay Installation must be installed in conjunction withthis service change.Associated Documents: G450 Aircraft Maintenance Manual (AMM), Chapters 20and 31GIVX-GER-9934 – PlaneView Software Verification andReturn-to-Service ProceduresGIVX-GER-7132 - Return-to-Service Checkout ProcedureFlight Manual Revision /Supplement Required:Aircraft operating under FAA regulations will require FAAAirplane Flight Manual (AFM) Revision 19, or laterapproved version, as a result of this service change.Aircraft operating under EASA / JAA regulations willrequire JAA Airplane Flight Manual (AFM) Revision 8, orlater approved version, as a result of this servicechange.Publications Data:Data concerning this service change will be published ina future revision of the affected manual(s). This bookletwill provide technical data until the revision(s) ispublished.Effectivity:This service change is applicable to Gulfstream G450aircraft serial numbers 4001 - 4114.This or a similar change will be installed during InitialPhase on Gulfstream G450 aircraft, serial numbers 4115and subsequent.Effect on Spares:NonePage 2 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"Special Equipment / ToolsRequired:Aircraft PC Laptop with Remote Terminal Tool version17.6 or later. Refer to Gulfstream PlaneViewMaintenance Applications disk version 6.0 or later, PN1159LAP59000.Skill Type Required:Knowledge of the Gulfstream G450 PlaneView avionicssystem will be required for this installation.Price:Installed Price:Prices are subject to change without notice.*See NotesKit Price only: Domestic: *See NotesInternational:*See Notes*NOTE:This aircraft service change is a managed program. Incorporation must becoordinated through Gulfstream Aircraft Scheduling at 800-810-GULF(4853) or 912-965-4178. If not scheduled, aircraft downtime could increasesignificantly.The installed price of this service change is included with the price of G450ASC 037 if installed at a Gulfstream facility.Page 3 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"MODIFICATION INSTRUCTIONS:A. Prepare aircraft for safe maintenance. Refer to G450 AMM, Chapter 20.NOTE:In-Service Evaluation participants complete a full software load inaccordance with GIVX-GER-9934. Skip Steps B and E of this ASC. Recordthe 16-digit Integrated Navigation Data Service (INDS) serial number fromthe Charts Revision page. This number will be needed to access the aircraftcharts after the software loading is complete in Step F of this ASC. PerformSteps C, D and F through O.B. Complete Steps A through D of ASC 052, PlaneView Avionics Enhancement (SV-PFD).C. Apply electrical power to aircraft. Refer to G450 AMM, Chapter 20.NOTE:Correct setup of the aircraft laptop with the CMC Remote Terminal Tool iscritical to the successful loading and operation of all software. Follow DataLoad Guide procedures CAREFULLY. Ensure any firewalls, anti-virusprograms or wireless LAN connections are disabled and the laptop isconnected to 60 Hz aircraft power.D. Load PlaneView Master Operating System software, PN EB7031236-00411, inaccordance with GIVX-GER-9934 Rev. “H” or later approved version, Section 2.0,PlaneView Software Loading. Remove MOS disk from laptop and store in aircraft.NOTE:Testing of this installation and the installations found in G450 ASC 052should be conducted only after all of the hardware and software installationsare completed. GIVX-GER-7132 is the only required test.E. Comply with G450 ASC 052 Steps E.1 through 12.F. Verify all software loads in accordance with GIVX-GER-9934 Rev. “H”, or laterapproved version, Section 6.0. Enter 16-digit INDS serial number recorded in ASC 052Step A.3 to access charts information as required.G. Perform a fault history database (FHDB) reset as follows:1. Select administrative tools under the settings tab from the CMC Remote Terminalon the aircraft laptop. Refer to Figure 2.2. On the administrative options page, enter password “GPV” and select execute.Refer to Figure 3.H. Perform Return-to-Service (RTS) Checkout Procedure GIVX-GER-7132 provided withthis service change.I. Verify Top-Level System software part number on Configuration Management Software(CMS) screen matches the part number on the MOS disk. Refer to Figure 1.Page 4 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"J. Discard previously used version of the PlaneView MOS disk.K. Remove electrical power from aircraft. Refer to G450 AMM, Chapter 20.L. Ensure work area is clean and clear of foreign object debris (FOD).M. Document the following software information on the attached service reply card and onthe PlaneView Configuration Record in the aircraft permanent maintenance records.Refer to Figure 1:• Top-Level System Part Number• Media Part Number• Media Serial NumberN. Record compliance with this aircraft service change in the aircraft permanentmaintenance records and return aircraft to flight status.O. Report compliance with this aircraft service change to Gulfstream CMP via electronictransmittal or fill out and fax the attached service reply card.WEIGHT AND BALANCE DATA:The effect of this change on the aircraft basic weight andbalance is 0.MOD WEIGHT HORIZONTAL MOMENTASC 907 0 - -ELECTRICAL LOAD ANALYSIS DATA:The effect of this change on the aircraft electricalloading is 0.PARTS REQUIRED PER AIRCRAFT:Item Part Number Nomenclature Qty. Notes/Alt./SubstitutesMaster OperatingMM7033384-0121. EB7031236-004111Software(media number)Return-to-Service2. GIVX-GER-71321Checkout ProcedureNOTE:All software media required for this ASC will be issued as a separatepackage by P/N 1159ASC47907-SW.All drawings, publications and media software will be issued to the latestrevision level.Page 5 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"Top LevelSystem PartNumberMedia PartNumberMedia SerialNumberFIGURE 1Page 6 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"FIGURE 2Page 7 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"FIGURE 3Page 8 of 8

Gulfstream G450 Aircraft Service Change 907“September 8, 2008"SERVICE REPLY CARDPLEASE FAX THIS PAGE TO GULFSTREAM AEROSPACE CMPat 866-827-7642 or 912-965-3598.THE FOLLOWING AIRCRAFT SERVICE CHANGE HAS BEEN COMPLIED WITH:ASC NUMBER A/C AIRCRAFT TYPE COMPLIANCE DATE979070 G450AIRCRAFT HOURS:AIRCRAFT LANDINGS:PREVIOUSLYCOMPLIED WITH (PCW):DATE:NOT APPLICABLE:DATE:MEDIA TITLEMOSTOP LEVELSYSTEM PARTNUMBERSOFTWARE INFORMATIONMEDIA PARTNUMBERMEDIA SERIALNUMBERCMP CODEOFF: 319010 / 319012ON: EB7031236-00411 MM7033384-012 319010 / 319012SIGNATURETITLE / CERTIFICATENUMBERCOMPANYCOMMENTS / SUGGESTIONS / ACTIONS TAKEN:Aircraft Service Change prepared by Gulfstream Aerospace, Savannah International Airport, PO Box 2206, SavannahGeorgia, 31402-2206, USA. © 2008, Gulfstream Aerospace. All rights reserved, including the right to reproduce thispublication. No part may be reproduced, stored in any retrieval system or transmitted in any part or form or by anymeans electronic, photocopying, microfilm, microfiche, mechanical or otherwise, without prior written permission ofGulfstream Aerospace.This technical data is controlled under the Export Administration Regulations by General License TSU. It may not betransferred to a third party without the prior written approval of the U.S. Department of Commerce.