SRP-350II - BIXOLON

More documents

Recommendations

Info

SRP-350II• Table 1 – Baud rate (bps) SelectionTransmission Speed 1-6 1-7 1-8 Default2400 ON OFF OFF4800 ON OFF ON9600 OFF ON OFF19200 OFF OFF OFF 960038400 OFF ON ON57600 OFF OFF ON115200 ON ON ON• Table 2 – Print Density SelectionPrint Density 2-5 2-6 Default1 (Light) ON ON2 (Medium) OFF OFF23 (Dark) ON OFF※ Auto Cutter Enable / Disable selectionDip Switch Set 2ONAuto Cutter DisabledSW 2-3OFFAuto Cutter EnabledApplicationIgnores Auto Cutter error for continuous printing.Rev. 1.01 - 12 -
SRP-350II1-5 Installing or Replacing the Paper Roll※ NOTEBe sure to use paper rolls that meet the specifications. Do not use paper rolls that havethe paper glued to the core because the printer cannot detect the paper end correctly.1-5-1 Make sure that the printer is not receiving data; otherwise, data may be lost.1-5-2 Open the paper roll cover by pressing the cover-open button.※ NOTEDo not open the print cover while the printer is operating. This may damage the printer.1-5-3 Remove the used paper roll core if there is one.1-5-4 Insert the paper roll as shown.Rev. 1.01 - 13 -
Page 3 and 4: SRP-350IICAUTIONViolating following
Page 5 and 6: SRP-350II■ IntroductionThe SRP-35
Page 7 and 8: SRP-350II1. Setting Up the Printer1
Page 9 and 10: SRP-350II1-2-2 Parallel Interface (
Page 11: SRP-350II1-4 Setting the Dip Switch
Page 15 and 16: SRP-350II1-6 Adjustments and Settin
Page 17 and 18: SRP-350II2. Self TestThe self-test
Page 19 and 20: SRP-350II4. SpecificationPrinting m

SRP-350II - BIXOLON

Create successful ePaper yourself

Delete template?

Save as template?