TruFit Door & Panel - Cardinal Shower

TruFit Door & PanelINSTALLATION INSTRUCTIONSSTEP 22Double-check that the height of the Glass Panel (P) is even with the GlassDoor (O) and 1/8” gap between pieces of glass is uniform. (See figure 22)STEP 23Silicone the Glass Panel (P) in place by applying an even bead insidetroughs on both sides of Wall Channel (C) and Curb Channel (D) as wellas where the wall channel and curb channel meet the wall and base. (Seefigure 23)Wipe excess silicone off with Cardinal Clean-Ups (V).WALLFIGURE 22STEP 24We have supplied two extra #8 x ¾” Self Tapping Screws (L).WE RECOMMEND PUTTING THESE ON THE OUTSIDE OF THE UNITFOR EXTRA SUPPORT.These are not necessary, but highly suggested to eliminate any movementduring usage. Using a 1/8” drill bit, drill two pilot holes through both theHinge Jamb (B) and the Wall Jamb (A) centered vertically with the DoorHinges (E). (See figure 24)SILICONEGLASSSILICONEWALL CHANNEL (C)FIGURE 23STEP 25Apply a bead of silicone where the Wall Jamb (A) meets the wall on BOTHsides. (See figure 25)FIGURE 24FIGURE 25Updated Dec 1, 2012Cardinal Shower Enclosures are manufactured by Hoskin & Muir, Inc.Page 93

TROUBLESHOOTINGTruFit Door & PanelINSTALLATIONIf, while preparing to attach the Hinge Jamb (B) to the WallJamb (A), you are unable to get a consistent 1/8” gapbetween the Door Glass (O) and Panel Glass (P) withoutrevealing the groove lines on the Wall Jamb (A), either yourwalls may be seriously out of plumb or your selected unitmight not be the right size for your conditions. Double checkyour wall conditions and measurements.OPERATIONIf you have not installed the #8 x 3/4” Set Screws (L) on theoutside of the enclosure securing the Hinge Jamb (B) to theWall Jamb (A), and you are noticing movement of the HingeJamb (B) during normal operation, we strongly suggest yougo to Step 24 and install the Set Screws (L) on the outsideof the enclosure.INSTALLATION INSTRUCTIONSWARRANTY CLAIMSTo make a claim under the provisions of this warranty, pleasecontact your local Cardinal Shower Enclosure dealer. Theyshould be able to solve any problem you might have.If your dealer cannot solve your problem, they will contact orsupply you with the name of your local Cardinal ShowerEnclosure distribution center.If you are unable to obtain warranty service through your localCardinal Shower Enclosure distribution center, you can contactus at:Cardinal Shower Enclosures4795 Shepherdsville RoadLouisville, KY 40218 USAE-mail: info@cardinalshower.comPlease include all relevant information regarding your claim:The model which was installed.The name and address of the installer.The installation addressA complete description of the problemA photocopy of your invoice/receipts for the product installedUnder no circumstances should Cardinal Shower Enclosuresproducts be returned to your dealer, distributor, or to CardinalShower Enclosures without a written Return MerchandiseAuthorization (RMA).Updated Dec 1, 2012Cardinal Shower Enclosures are manufactured by Hoskin & Muir, Inc.Page 97

This page intentionally left blank.Page 98Cardinal Shower Enclosures are manufactured by Hoskin & Muir, Inc.Updated Dec 1, 2012