TRX 350 4x4 - 4 Wheel Online

Place the proper U-Clamp and U-Clamp Spacer on the Brush Guard. Connect the L-Brace tothe U-Clamp with the 5/16” x 2” Carriage Bolt and Nylock Nut.TIGHTEN ALL BOLTS SECURELYLEFT SIDE VIEWOF BRUSH GUARD AREA8. SEE SWITCH AND WIRING INSTRUCTIONS.Using the winch, CAREFULLY raise the blade and OBSERVE the Push Tube Frame.RELEASE THE WINCH SWITCH SO THE PUSH TUBE FRAME STOPS 1" FROM THE ATVFRAME. Place the Winch Cable Stop on the winch cable, so the Cable stop is against theWinch body. TIGHTEN THE CABLE STOP SECURELY.ALWAYS RELEASE THE WINCH SWITCH WHEN THE CABLE STOPS AGAINST THE WINCHBODY.DO NOT FEED OUT EXCESS CABLE WHEN LOWERING THE BLADE. RELEASE WINCHSWITCH WHEN THE BLADE CONTACTS THE GROUND4