TRX 350 4x4 - 4 Wheel Online

More documents

Recommendations

Info

Place the proper U-Clamp and U-Clamp Spacer on the Brush Guard. Connect the L-Brace tothe U-Clamp with the 5/16” x 2” Carriage Bolt and Nylock Nut.TIGHTEN ALL BOLTS SECURELYLEFT SIDE VIEWOF BRUSH GUARD AREA8. SEE SWITCH AND WIRING INSTRUCTIONS.Using the winch, CAREFULLY raise the blade and OBSERVE the Push Tube Frame.RELEASE THE WINCH SWITCH SO THE PUSH TUBE FRAME STOPS 1" FROM THE ATVFRAME. Place the Winch Cable Stop on the winch cable, so the Cable stop is against theWinch body. TIGHTEN THE CABLE STOP SECURELY.ALWAYS RELEASE THE WINCH SWITCH WHEN THE CABLE STOPS AGAINST THE WINCHBODY.DO NOT FEED OUT EXCESS CABLE WHEN LOWERING THE BLADE. RELEASE WINCHSWITCH WHEN THE BLADE CONTACTS THE GROUND4
CAUTIONBE AWARE OF THE CABLE STOP CONTACTING THE ROLLERHAWSE WHEN THE CABLE IS WOUND IN.FAILURE TO RELEASE THE SWITCH MAY CAUSE DAMAGE TOWINCH PARTS OR TO THE ATV.When using the Winch to raise and lower a Cycle Country Plow, aCable Stop must be installed.Hook the Winch Cable to the CYC0345 (U608) (item #4 on your 15-0001 push tubekit) through the slotted hole. Carefully raise the blade until the top of the push tubeare no closer than 1” anywhere on the ATV. Place the Cable Stop onto the WinchCable up against the Winch Hawse. Secure the Cable Stop to the Winch Cable usingthe Cable Clamp Assembly as shown in the pictures below.5
Page 1 and 2: HondaTRX 350 4x4WINCHMOUNT KITINSTA
Page 3: HONDA TRX 350 4x4 WINCH ATTACHING K

TRX 350 4x4 - 4 Wheel Online

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?