Iskra Zascite

CCP-UHF SeriesCOAXIAL/RF PROTECTIONIEC category / EN type: C1/C2/C3 (IEC 61643-21)Design:In-line. Impedance matchedMax. Operating Voltage U C:70, 180, 280VMax. Peak Power:40, 125, 300W respectivelyFreq:DC 600MHzCharacteristic Impedance: 50ΩInsertion loss:< 0.4dBReturn loss:> 20dBSurge Discharge Ratings: I N: 10kA 8/20µs, I MAX : 20kA 8/20µsEnclosure:Shielded enclosure, in-line installationTermination:UHF - Type. M-F and F-F availableThe CCP-UHF series of coaxial surge protectors is intended to protect RF antenna systems and is suitable forfrequencies from DC to 600 MHz.It is designed as an in-line unit allowing ease of installation. The careful design, low capacitance gas dischargearresters and high quality UHF-type termination connectors, ensures a minimum of insertion loss throughout thefrequency band.Transfer power is 40W to 300W continuous (depending on CCP voltage) .The CCP coaxial cable protector is designed in accordance with the following standards and regulations:- IEC 61643-21:2000A grounding stud is provided which should be connected to the system ground, or coaxial feed-through bulkhead,as directly as possible.Technical characteristicsType CCP70 CCP180 CCP280 CCP70 CCP180 CCP280-UHF-FF -UHF-FF -UHF-FF -UHF-MF -UHF-MF -UHF-MFMax. Continuous operating voltage U C70V 180V 280V 70V 180V 280VMax. peak power 40W 125W 300W 40W 125W 300WImpedance50ΩFrequency range 0 - 600MHzInsertion losses < 0.4dBReturn losses > 20dBNom. discharge current (8/20µs) I n10kAMax. discharge current (8/20µs) I max20kAResidual voltage (1kV/µs) < 600V < 700V < 900V < 600V < 700V < 900VInsulation > 10GΩWeight 104g 104g 104g 104g 104g 104gOperation temperature - 40oC … + 80oCStyle of connector UHF female / female UHF male / femaleOrdering code 800 735 800 736 800 737 800 738 800 739 800 740Dimensional drawingsConnection diagramCCP-UHF-MF2565CCP-UHF-FFLINELINE25SHIELDSHIELD60PEwww.iskrazascite.si67