APPROVED MATERIALS LIST (AML) - City of West Palm Beach

Submittal:DUCTILE IRON FITTINGS (CONTINUED)FLANGED JOINT RESTRAINT:Flange Bolts and nuts shall be carbon steel, hex head, ASTM A183, with Zinc electroplated finish. The flange typegasket material shall be 1/8-inch thick rubber type conforming to ANSI B16.21 and AWWA C-207, unless otherwisespecified. For all joint restraint products, apply corrosion resistant coating Mega-bond (or approved equal). Polyesterbased powder electro-statically applied in two coats and heat cured after each coating for cast body. Xylanflouropolymer coating will be used for wedge assemblies. Applicable for all restraint devices through 24”.____ EBAA IRONMegalugSeries 2100APPROVED JOINT RESTRAINT FITTINGS:____ UNION FOUNDRYSwivel Joint FittingsAPPROVED JOINT RESTRAINT FOR PVC:In some cases there are existing PVC water mains that need to be cut or tied into and restrained back due to theaddition of elbows, tees and valves. This section covers the types and approved joint restraint allowed. For all jointrestraint products, apply corrosion resistant coating Mega-bond (or approved equal). Polyester based powder electrostaticallyapplied in two coats and heat cured after each coating for cast body. Xylan flouropolymer coating will beused for wedge assemblies. Applicable for all restraint devices through 24”.BELL RESTRAINTS:____ EBAA IRONSeries 1600(4” through 12”)Series 2800 (14” through 36”)TIE RODS AND ACCESSORIES: (Utilized As Required By The City)____ SIGMA PRODUCTS:Duc Lugs (bent eye bolts not allowed):Socket Clamps (with cast iron washers)All thread rod, zinc plated (¾” only)- End of Section -Page 13 of 54 Approved Materials List – Revised November 1, 2011