APPROVED MATERIALS LIST (AML) - City of West Palm Beach

Submittal:TAPPING SLEEVES & SADDLESTAPPING SLEEVES:DUCTILE IRON:Allowed for 4" and larger size taps. May be used on DIP, CIP, ACP and PVC. For use on Distribution System WaterMain and/or Sanitary Sewer Collection Force Main. Ductile iron with mechanical joints.____ AMERICAN ____ CLOW ____ MUELLER ____ U.S. PIPE2800 F-5200 Series H-615 Type 91004 H-616List sizes to be used: .STAINLESS STEEL:Allowed only when tapped line is more than twice as large as tapping diameter (i.e., 12 x 4 is allowable, a 12 x 6 is notallowed). For use on Distribution System Water Main and/or Sanitary Sewer Collection Force Main. All 304 stainlesssteel (SS), with 304 SS hardware for water or force main taps. May be used on DIP, CIP, AC, PVC.____ JCM ____ MUELLER ____ SMITH BLAIR ____ ROMAC ____ FORDH304 (Rockwell) 419 FAST CST-ST,622 SST, or FTSSList sizes to be used: .NOTE: The following materials shall be used when an existing PVC or Transite water or force main is encounteredand a sample point, air release, or test tap needs to be installed.SERVICE SADDLES:All brass shall be of no-lead brass (maximum lead content of .10% by weight). All straps shall be either doublestainless steel or single wide stainless steel strap with two bolts on each side of the strap. Use, size, and tappingthread for the corporation to be attached to the saddle shall be as follows:A. Water Services: Only 1" and 2" AWWA tapping thread are allowed.B. Sample Point/Vent pipe (temporary):1" AWWA tapping threadC. Terminal Blow-offs: 2" Iron pipe tapping threadD. Air Releases: 1-1/2"x 2" AWWA tapping threadList the following with each saddle to be used:A. Size(s) of pipe to be tapped ___________________ ,B. Type(s) of pipe to be tapped __________________ ,C. Size(s) of tap to be made _____________________,D. Use (See A through D above) _________________,____ FORD202BS Double Band Brass Saddles- End of Section -Page 19 of 54 Approved Materials List – Revised November 1, 2011