ALUCOBOND Verarbeitung - Ravago

ROUTING AND FOLDING TECHNIQUEFabrication of tray panelsDetermination of the measures of periphery and routing measuresThe measures of periphery and the routing measures are determined onrouting measurethe basis of the drawing measures (final measures). In this case, approx.approx.approx.1 mm per edge is deducted from the final measure. 1 mm The total of the 1 mm routingmeasures results in the cutting measure. In any case, final the measure final measuresshould be checked using a test strip prior to series production. Thenthe limit stops of the panel saw can be adjusted to obtain elements ofidentical sizes.Determination of the cutting measureExample ALUCOBOND ® roof edge:Total of routing measures = cutting measure = 1292 mmfinal measurerouting measureapprox.1 mm300 final measure298 routing measurecut off the completemilled grooveapprox.1 mmrouting measurefinal measureapprox.1 mmfinal measurerouting measure800 final measure798 routing measure50 final measure49 routing measureapprox.1 mm50 final measure49 routing measure100 final measure098 routing measurecut off thegroove basepunching upto centre ofmilled grooveV-groove90°For dimensionsrelating to traypanels, pleasesee examples“Suspendedtray panels”Determination of the routing measureAdjustment of punch depth300 final measure298 routing measureAdjustment of the punching depth when punching cornersIn order to obtain perfectly closed tray corners, the machine settingsindicated in the sketch must be observed.800 final measure798 routing measure50 final measure49 routing measure50 final measure49 routing measureFor clean cuts use sharp tools and dies with minimal cutting clearance(~ 0.1 mm).4final measure10routing measure82Bending aids100 final measure098 routing measureFor easy folding of ALUCOBOND ® , particularly in the case of narrowfolds processed according to the routing and folding technique, werecommend bending aids that can be produced of ALUCOBOND ® buttjoint sections and panel strips.--Butt joint section4 mmSection No. 31343--Butt joint section6 mmSection No. 31344Minimum double foldsALUCOBOND ®panel stripEdition 1ALUCOBOND ® Processing and Technical Data GB19