Fitting Instructions - Paddock Spares

More documents

Recommendations

Info

Pointing to the three mounting holes for thelower hinge on the cross member.You may have to remove the handle if there isone fitted.This view is a cross-member as viewed from the front behind therear wheel arch. The spacing plate and lower hinge bracket areoffered up to the outer skin (rear of the cross-member).On the inside (front) of the cross- member, the two smaller boltspass through the outer cross-member skin and into a captive nutplate (supplied in the fixing kit).The larger bolt goes through the samesupport plate and then through the sleeve(also provided in fixing kit). It then passesthrough a second skin at the front of thecross-member before the nut is wound on.
Lift the main frame into position and slot thehinge bolts into place, using a plastic shimwashers above and below in the hinge.With the hinge bolts in place, tighten the x2upper hinge bolts (which were left loose duringfitment).Bolt the door cylinder assembly in place.Open the door while bringing the piston anddoor frame together. AND offer up the twoholes as you close the door again.
Page 1 and 2: Part NumberDA2232Fitting Instructio
Page 3: Position the new plate on the door

Fitting Instructions - Paddock Spares

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?