for docutech printing - Small Engine Suppliers

Replace Starter Rope1. Pull rope out part way and tie a temporary knot.2. Remove rope from rope handle and untie knot,Fig. 3.3. Remove starter handle.Fig. 411. Pull rope until knot is seated in pulley.12. Then let rope rewind into starter.13. Operate starter to check for smooth operation.Fig. 34. Pull rope out as far as it will go and untietemporary knot.5. While holding rewind pulley, grasp knot in pulleywith a pair of needle nose pliers and pull rope outof pulley.6. Slowly release spring tension on pulley untilpulley stops turning.NOTE: Replacement rope has handle attached.7. Rotate pulley CLOCKWISE, SEVEN (7)complete turns.8. Then rotate pulley counterclockwise until ropehole in pulley is in line with starter housingeyelet. Hold pulley in this position.Install Blower Housing – Direct Drive EngineAssemble blower housing to engine.NOTE: Be sure stop switch is installed in its notchin blower housing.1. Install 4 screws (2) from cylinder shield side,Fig. 5.Torque screws to 25 in. lbs. (3 Nm).9. Insert rope through eyelet in housing and thenthrough hole in pulley (1), Fig. 4.10. Tie a figure eight knot in end of rope (2), asshown.Fig. 513