for docutech printing - Small Engine Suppliers

5. Remove 4 screws (2) from cylinder shield side,Fig. 11.6. Remove blower housing.Fig. 117. Check ball bearing for rough spots or excessivelooseness (wear).a. If bearing is bad the blower housing must bereplaced.Starter rope inspection and replacement procedureis the same as direct drive engine.Fig. 133. Install thrust washer (1), Fig. 14.4. Assemble clutch to shaft with writing up (2).Hand tighten clutch.5. Assemble clutch drum to engine, Fig. 15.Torque screw to 20 in. lbs. (2.0 Nm).Install Blower Housing – Clutch Drive EnginePlace a drop of engine oil on ball bearing journal onflywheel nut/crank adapter.Assemble blower housing to engine.NOTE: Be sure stop switch wires are routedthrough blower housing.1. Install 4 screws (2) from cylinder shield side,Fig. 12.Torque screws to 25 in. lbs. (3 Nm).Fig. 14Fig. 122. Install 2 screws in blower housing, Fig. 13.Torque screws to 40 in. lbs. (5 Nm).Fig. 1515