11.07.2015 Views

Image 628 - Rick English - Swimming Pool Consultant

Image 628 - Rick English - Swimming Pool Consultant

Image 628 - Rick English - Swimming Pool Consultant

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

AssemblyBefore beginning assembly, carefully read thefollowing information and instructions:• Place all parts in a cleared area and remove thepacking materials from the spa shell. Do not disposeof the packing materials until assembly iscompleted and the spa is operating.• During assembly, make sure that all parts areoriented as shown in the drawings.• Read each assembly step before you begin.• Tighten all parts as you assemble them, unlessinstructed to do otherwise.ASSEMBLY REQUIRES THE FOLLOWINGTOOLS (not included):• One phillips screwdriver• You will also need a small amount of soap anda damp cloth.A wire connector is provided on the electronicspack of the spa to connect a minimum No. 6AWG (13.3 mm 2 ) solid copper conductorbetween the spa and any metal equipment,electrical enclosure made of metal, metal waterpipes, or conduit within five feet of the spa.1. Before beginning assembly, make sure that youhave read and understand the information in thebox above and on the previous two pages.Remove the four indicated #10 x 2” Sheet MetalScrews (6). Remove the Access Panel (15) by slidingit down and then pulling the bottom away from thespa. Be careful not to damage the spa shell.1Spa Shell61562. Locate the drain hose. Make sure that the cap (notshown) is fully tightened onto the end of the drainhose.Locate the two indicated gate valves inside of thespa. Make sure that the gate valves are open andthat the locking clips are snapped onto the stems ofthe gate valves as shown in the inset drawing.2Gate ValveCollarMake sure that all of the collars such as the oneindicated are tightened.See step 1. Re-attach the Access Panel (15) withthe four #10 x 2” Sheet Metal Screws (6).Locking ClipDrainHose8

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!