VRIOGS 010.4 RevA - Public Transport Victoria

VRIOGS 010.4 Revision A 23SECTION 16.0SECONDARY EQUIPMENT INSTALLATION16.1 415/240V SWITCHBOARDThis switchboard shall be manufactured as specified in the design. The switchboardshall be mounted so that the top is 1800mm from floor level and held to the wallusing 12mm anchors.16.2 DC SWITCHBOARDThis switchboard shall be manufactured as specified in the design. The switchboardshall be mounted on the wall so that the top is 1800mm from floor level and heldusing 12mm anchors.Both switchboards (415/240 AC switchboard and DC switchboard) shall be locatedas shown on Equipment Layout Drawing and wired up as per Auxiliary SuppliesDrawing.16.3 DC BATTERY CHARGER AND BATTERY BANKThese shall be installed as per design instructions and details.16.4 SUBSTATION LIGHTING AND POWER CIRCUITSThe lighting and power installation for the location shall be installed in accordancewith the specifications and drawings.16.4.1 LayoutThe position of all fittings shall be as set out in the Light and Power Layout drawing.Note that the circuits are supplied from 415/240V switchboard and 110V DCswitchboard for emergency lighting.Note the location and details of the special heavy current three-phase outlet.16.4.2 StandardsThe cabling to fittings, power sockets and light fittings shall comply with AS 3000, theregulations and standards as appropriate.Cables shall be placed in accordance with the specifications and drawings.NOTE: This document is controlled only when viewed on the DOT Engineering Standards website.Any other copy of this document is uncontrolled, and the content may not be current.