FD 260-10 Feeder for FD 260 Tabber - Formax

More documents

Recommendations

Info

4. SET-UPCAUTIONONLY PLUG THE POWER CORD INTO ANOUTLET AFTER READING SECTION 3 –POWER CONNECTION.123Figure 4.1 -- (1) Feed Wedge, (2) Product Stop Extension, (3) Power Cord4.1 Feed WedgeThe FEED WEDGE improves the feeding of certaintypes of mail pieces. To install the FEED WEDGE:1. Unscrew the FEED WEDGE knob from the tray.2. Align the long slot in the FEED WEDGE over oneof the holes in the center of the tray, with theangled edge of the WEDGE facing the FEEDROLLS.3. Screw the FEED WEDGE knob through the slotand into the hole.12
4.2 Product StopExtensionThe product stop extension allows you to stack 4extra inches of mail (8” total) in the FEED TRAY.PRODUCT STOPEXTENSIONNON-OPERATOR SIDEPRODUCT GUIDEOPERATOR SIDEPRODUCT GUIDEPRODUCT STOPKNOBSPRODUCT STOPFigure 4.2 – Product Stop ExtensionTo install the product stop extension:1. Loosen both PRODUCT STOP KNOBS securedto the top of the PRODUCT STOP (refer to Figure4.2).2. Slide the notches in the PRODUCT STOPEXTENSION around the screws in the PRODUCTSTOP KNOBS.3. Tighten the PRODUCT STOP KNOBS into thePRODUCT STOP. The PRODUCT STOPEXTENSION should be secured to the PRODUCTSTOP and <strong>for</strong>m a straight surface from the tray tothe top of the PRODUCT STOP EXTENSION(refer to Figure 4.2).13
Page 1: FD 260-10Feeder for FD 260 TabberOp
Page 5 and 6: 1. INTRODUCTION1.1 FD 260-10Descrip
Page 7 and 8: 1.3 OperatingManual SafetyTermsThe
Page 9 and 10: 1.6 WarrantyNOTEYour Formax FD 260-
Page 11 and 12: 2. SPECIFICATIONS & REQUIREMENTS2.1
Page 13 and 14: NOTEThe detachable POWER CORD may h
Page 15: 3.4 Power CordThe FD 260-10 comes w
Page 19 and 20: 2. Place the FD 260-10’s output e
Page 21 and 22: 5. Tighten each SEPARATOR KNOB, loc
Page 23 and 24: 6. MAINTENANCE6.1 Cleaning6.2 Repla
Page 25 and 26: 7. TROUBLESHOOTING7.1 Troubleshooti

FD 260-10 Feeder for FD 260 Tabber - Formax

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?