Piezo_Pneumatics~2001.pdf - Winco

More documents

Recommendations

Info

General purpose valves... the “Chip Valve” Series P10”Chip Valve”Piezo MiniatureValveSeries P10Versions– 3/2 way switching valvesnormally closed (NG)Special Versions (4(on request)–3/2 way switching valvesnormally open (NO)–2/2 way switching valves–3/2 way proportionalcontrol valves–2/2 way proportionalcontrol valves (4normally closed andnormally open versionsScope of supply–1 valve– Mounting kit consistingof 3 rollers and O-rings– 2 M2.5 x 25 mm screws– 2 EJOT 2.5 x 6 screws–1 connecting cable2 x 0.14, 300 mm,with connector(1Normally open (NO)version on request(2Nominal pressure p Nagainst atmosphere(3Voltages < 24 V on request(not for prop. control valves)(4Characteristics on request(5Not suitable as safetyvalve with 100% EDCharacteristics Symbol Unit DescriptionGeneral FeaturesSystemDirectly controlled (from system) proportionalcontrol or switching poppet valveMountingMetal screws(part of scope of supply)ConnectionFlange or nose nozzle (3 mm)Port size NW ca. 0.33Installation positionOptionalWeight g 20Flow direction ON: from 1 to 2(normally closed NG) (1OFF: from 2 to 3 (3/2-Way valve)Medium and ϑ min°C 0 other temperaturesambient temperature ϑ max°C +50 on requestrangeMediumFiltered air (30µ), other gases or fluidspossible on requestPneumatic CharacteristicsValve nominal pressure pN bar 0.1 bar 0.3 bar 0.6 bar 1.2 bar 2.0 barInput pressure range p1 min/max bar 0.05–0.15 0.2–0.3 0,5–0.7 1.1–1.3 1.8–2.2Output pressure range p2 min/max bar 0–0.1 0–0.3 0–0.6 0–1.2 0–2.0(proportional version)Flowrate (23/2 way models Q l/min 0.5 0.9 1.5 1.5 1.4Leckageinlet air side 4% of Qoutlet air side: 8% of QElectrical CharacteristicsOperating volatage UN V 24 DC (proportional control valve 0 – 24 V DC) (3Holding energy P W 0.006ConnectionRelative switching time ED % 100 (5Electrical protection IP 20Chip ValveType: P10-..-..-.-...2-pin connectorFlange mounting kitconsisting of 3 rollersand O-ringsfor M2.5 x 25screws20,512,54316for EJOT 2.5x6 screwson front and rear1 21 223,533332,64 26,933,51 282,6243,8272,0283,822ø312
3/2 Way Piezo Valve Series P20-OEMSeries P20-OEM – NW 2.0Characteristics Symbol Unit DescriptionGeneral FeaturesSystemPoppet valve system,pneumatic pilot control withpiezo valve, some overlapMountingFlange (see dim. drawing)Pipe connectionFlangePort sizeNW2Weight (mass) kg 0.100Flow direction ON: from 1 to 2OFF: from 2 to 3 (1Installation positionOptionalMedium and ϑmin. / max. °C -10 to +60ambient temperatureNote: Contact technical departrangement advice if used intemperatures between-30 and +80°CMediumDry or filtered air (30µ), no orminimal oil mist lubrication(max. 30mg/m 3 )3/2 WayPiezo ValveSerie P20-OEMNW 2Versions– normally closed (NG)– normally open (NO)Note:The valve for the P20-OEMseries fulfils the requirementsfor approval as anintrinsically safe device whenused with an appropriatecontroller.Pneumatic CharacteristicsNominal pressure pmin. / max. bar 6Operating pressure pmin. / max. bar 1.5 – 8Nominal flow QN l/min 130 (from 6 to 5 bar)Nominal size mm 2.0Electrical CharacteristicsNominal voltage UN V DC 24Capacity C nF < 100Switching energy E mWS 0.014Holding energy P W 0Duty cycle ED % 100ConnectionCable 300 mm longSwitching time tON ms < 20 (10% of discharge pressure)tOFF ms < 20 (90% of discharge pressure)Electrical protection IP 20 ( 2( 1 outlet air not included( 2 not suitable as safety valve with 100% EDType: P20 381RF-.-COEM3Connecting cable 300 mm242,5M47,5116532,52132,5Base plate see page 3113
Page 1 and 2: CONTROL ELEMENTSPneumatic
Page 3 and 4: ContentsPageHow do piezo valves wor
Page 5 and 6: in Explosion AreasOut 24VProfibus D
Page 7 and 8: General purpose valves7
Page 9 and 10: 3/2 Way Piezo Valves NW 2 - Series
Page 11: General purpose valves3/2 Way Piezo
Page 15 and 16: Directional Valves with NAMUR Conne
Page 17 and 18: CharacteristicsSeries S29 - G1/4 an
Page 19 and 20: **Series S9 - with EEx m-Solenoids5
Page 21 and 22: Directional Valves, intrinsically s
Page 23 and 24: Directional Valves - intrinsically
Page 25 and 26: Directional Valves - with EEx m-Sol
Page 27 and 28: Directional Valves - intrinsically
Page 29 and 30: Directional Valves to ISO 5599 - in
Page 31 and 32: Series P20 - intrinsically safe, pi
Page 33 and 34: 5/2 and 5/3 Way ValveSeries S9 - in
Page 35 and 36: Way Valve to ISO 5599Series S20 - i
Page 37 and 38: 413/2 Way ValveSeries S9 - with EEx
Page 39 and 40: 415/3 Way ValveSeries S9 - with EEx
Page 41 and 42: P-Supply Manifolds for Directional
Page 43 and 44: Series PL-1/4-..MaterialDescription
Page 45 and 46: Series PL-1/2-.MaterialDescriptionP
Page 47 and 48: Series RPSL-1/4-..MaterialDescripti
Page 49 and 50: Base Plates CombinationsIntermediat
Page 51 and 52: Dimensions Table (mm)ISO Number A B
Page 53: Safety barriers (Zener barriers)Man
Page 57 and 58: AIRFIT CONTROLElectronically contro
Page 59 and 60: Dimensions (mm)Manifold Base Plate
Page 61 and 62: airfit tecno:ProportionalPressure R
Page 63 and 64:
PARAMETERS TO VDI 3292ORDER INSTRUC
Page 65 and 66:
AIRFIT SRT AND CRT:THE COMBINATION
Page 67 and 68:
airfit SRT and CRT:Pressure Regulat
Page 69 and 70:
○ ○ ○ ○ ○ ○ ○ ○ ○
Page 71 and 72:
WORTH KNOWING:THE FINE DISTINCTION
Page 73:
HOERBIGER-ORIGA...your competent pa
show all

Piezo_Pneumatics~2001.pdf - Winco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?