PDF Download - LIG Nex1

Debug mode• Display information of a noise or signal detected in Scan mode under theSpectrum Analyzer mode in details• This mode sweeps just as Spectrum Analyzer• Use of 6dB IF BW Filter (1MHz Impuse ~ 10Hz, 10 units in total)• Sweep from 3Hz to 26.5GHzEdit limit line• Draw and edit limit lines for any user’s needs• Different colors of lines for better view• Save, load, edit each Detector• Maximum 200 points availableEditing Correction File• Direct editing of a variety of Correction Factors• Correction by entering a negative value for gains and a positive value for loss due to Amp• Designating up to 8,192 positions• Correcting the whole range in case there is a single corrective value• Correction through a linear interpolation between correction points• Identified by four factors of Antenna, Cable, Other, and UserReal data for limit line• Save and load the test results into .EMT file• Available general text editor(notepad, wordpad, word)• Editing available on a general PC and LSA• Edit with the Microsoft excel programReal data for antenna• Save and Load the test results into .ANT file• Available general text editor(notepad, wordpad, word)• Edit the test results with Microsoft Excel program5