Nova DVR 3000 Manual_22 November 2002 - Teknatool

change in spindle conditions and compensate accordingly, get a feel of the communicationbetween yourself and the motor turning by applying increasing force, the motor will respond byapplying increased power to exactly maintain speed.Swiveling the Headstock1. Stop the lathe. Insert the operatingbar into a hole in the HeadstockLockpin. Loosen the Lockpin half aturn.HeadstockHeadstockRelease Handle2. Slide the Headstock ReleaseHandle towards outboard end oflathe, and rotate the headstock to adetent position. Do not push downon the handle.! Warning!Use the detent latch positionsto prevent headstock movementduring turning.4. Firmly tighten the HeadstockLockpin with the operating bar;but do not use excessive force.Remove the operating bar.HeadstockLockpinOperating Bar180°right-hand Turners90°337.5°0°22.5°45° Detent Positionsleft-hand TurnersDetent Positions 0, 22.5, 45, 90 degrees 180, 337.5 degreesSpindle IndexThe spindle index pin locks theheadstock spindle. It is selectable in 15degree increments (24 divisions). Thereis sight hole to read index numbers(0 through 23).1. Stop the lathe.2. Pull the index knob and turn it leftuntil the pin drops into the hole. Tolock the spindle it must engage intoa hole in the headstock pulley.! Warning!Make sure the index pin isout before operating the lathe.The pin should drop into theindentation in the headstock toprevent it from engaging whilethe spindle is turning.Divisions Index Number Degrees2 0,12 1803 0,8,16 (every 8th) 1204 0,6,12,18 (every 6th) 906 0,4,8,12,16,20 (every 4th) 608 0,3,6,9,12,15,18,21 (every 3rd) 4512 0,2,4,6,8…22 (every 2nd) 3024 every hole 1518 101-0505-002