FASTENERS - CHROMATE - Chromate Industrial Corporation

TAPER BOLT ANCHORSHIGHEST TENSILE AND SHEAR STRENGTH OF ANY EXPANSION ANCHOR• GRADE 5, ZINC PLATED TAPER BOLT – FOR STRENGTH, DURABILITY AND CORROSION RESISTANCE• REQUIRED HOLE DIAMETER EQUALS ANCHOR DIAMETER – NO REPOSITIONING OF EQUIPMENT REQUIRED• UNDERSIZE/OVERSIZE HOLES CAN BE ACCOMMODATED BY TURNING THE PRE-EXPANDED NUT A FEW TIMES• EQUIPMENT MAY BE REMOVED AND REPLACED – THE BOLT IS SIMPLY RE-INSERTED AND TORQUED TO OBTAINORIGINAL HOLDING POWER (THE NUT STAYS IN THE HOLE)• BOLT CAN BE REMOVED AND RE-USED WITH A NEW NUT• THE HIGHEST TENSILE STRENGTH AND SHEARSTRENGTH OF ANY EXPANSION ANCHOR• WITHSTANDS VIBRATORY LOADSBETTER THAN ANY OTHEREXPANSION ANCHORINSTALLATION PROCEDURE1. Drill hole the same diameter as the Taper Bolt, using fixture as atemplate.2. Drive Taper Bolt into place leaving recommended head clearance.If hole is oversized, simply remove and pre-expand the expandernut to fit hole.3. Tighten Taper Bolt to recommended torque.4. For larger projects, set Taper Bolt with an impact wrench. Thismethod offers speed, consistency and greater installer productivity.211. 2. 3. 4.ANCHOR REQUIRED REQUIREDDIAMETER MINIMUM TORQUE HEADAND HOLE EMBED- TO SET CLEAR-LENGTH DIAMETER MENT (FT. LBS.) ANCE3/8 x 2-1/43/8 x 2-5/83/8 x 33/8 x 43/8 Nut only1/2 x 2-7/81/2 x 41/2 x 51/2 Nut only5/8 x 3-1/25/8 x 4-1/25/8 x 65/8 x 75/8 Nut only3/4 x 4-1/83/4 x 5-1/23/4 x 73/4 x 83/4 Nut only1 x 5-5/81 x 7-1/41" Nut onlyULTIMATE TENSILE & SHEAR LOADS IN LBS.CONCRETE STRENGTH (P.S.I.)3000 PSI 5000 PSITENSION SHEAR TENSION SHEAR3/8" 1-7/8" 40 3/16" 4,030 7,177 4,987 8,5671/2" 2-3/8" 90 1/4" 8,165 12,177 9,346 15,2175/8" 2-5/8" 125 5/16" 9,990 17,030 10,470 17,2573/4" 3-3/8" 250 7/16" 11,906 27,916 17,073 28,1101" 4-5/8" 550 5/8" 28,263 36,257 30,817 38,487IIIIIEEBIBBBBEBBBBEAABPART7768077681776827768377680N77684776857768677684N7768777688776897769077687N7769177692776937769477691N776957769677695N21.22 FOR MORE INFORMATION ON OUR PRODUCTS OR SYSTEMS, CALL 1-800-BUY-BOLT030114