(ACS) Technical Manual - Alaska Clean Seas

More documents

Recommendations

Info

TACTIC S-3 Identifying Required Personal Protection (Page 3 of 4) Identifying Required Personal Protection (Page 4 of 4) TACTIC S-3GUIDELINES FOR PPERESPIRATORY:A NIOSH approved air purifying respirator with an organic vapor cartridge may be used under conditions whereairborne concentrations are expected to exceed permissible exposure limits. All employees need to be fit tested forthe particular brand and model they will be expected to use.A Respiratory Protection program that meets OSHA’s 29 CFR 1910.134 and ANSI Z88.2 requirements must befollowed whenever workplace conditions warrant a respirator’s use.THIS PAGE DELIBERATELY LEFT BLANKSKIN:The use of gloves impervious to the specific material handled is advised to prevent skin contact, possible irritation,absorption, and skin damage.Recommended Use: Depending on conditions the use of aprons and or arm covers may be necessary.Note: These are just recommendations; each company may purchase and use their PPE of choice. Below is asimple guideline for petroleum PPE selection. It is still necessary for a “competent person” to determine PPE usagefor each specific response incident. Surgical grade gloves are not a recommended substitution for industrial usechemical protective gloves. Read the manufacturers recommended application before using any product.GLOVE MATERIALButylNeopreneNitrilePVCPVAVitonSilver Shield4HNatural (Latex) rubberGENERAL USESOffers the highest resistance to permeation by most gases and water vapor. Especially suitable foruse with esters and ketones. Poor for aliphatic, aromatic hydrocarbons, halogenated hydrocarbons,and gasoline.Good for acids and bases, peroxides, fuels, hydrocarbons, alcohols, phenols. Poor for halogenatedand aromatic hydrocarbonsExcellent general duty glove. Provides protection from a wide variety of solvents, oils, petroleumproducts, and some corrosives. Excellent resistance to cuts, snags, punctures, and abrasionsProvides excellent abrasion resistance and protection from most fats, acids, and petroleum hydrocarbons.Poor for most organics (consult a competent person prior to use).Highly impermeable to gases. Excellent protection from aromatic and chlorinated solvents. Cannotbe used in water or water-based solutions.Exceptional resistance to chlorinated and aromatic solvents. Good resistance to cuts and abrasions.Resists a wide variety of toxic and hazardous chemicals. Provides the highest level of overallchemical resistance.Same as Silver Shield, but offers better dexterity.Good for very dilute acids and bases. Poor for organics (consult a competent person prior to use).EYE/FACE:Approved eye protection to safeguard against potential eye contact, irritation, or injury is recommended. Dependingon conditions the use of a face shield over safety glasses or goggles may be necessary.OTHER PROTECTIVE EQUIPMENT:It is recommended that protective clothing be worn when skin contact is possible such as:• Tyvek (light duty clean up)• Saranex• Dupont level “B”It is required to consult with a “competent person” for job specific PPE requirements. Eye wash and quick drenchshower facilities should be available in the work area. Thoroughly clean shoes and wash contaminated clothingbefore reuse.ACS Tech. Manual Vol. 1, 03/12 NOTE: All values given on these pages are for planning purposes only.NOTE: All values given on these pages are for planning purposes only. ACS Tech. Manual Vol. 1, 03/12
TACTIC S-4 Site Layout (Page 1 of 2) Site Layout (Page 2 of 2) TACTIC S-4NOTE: “Base Location” is storage location (may change seasonally); “Mobe Time” is time to get it out of storage, prepare it foroperation, and make it ready to travel (concurrent for all equipment); “Deploy Time” is time to make it operational for its intended useat the spill site. These times do not include travel time from base to spill site, which may have multiple components (see Tactic L-3).HOT ZONE(Exclusion Zone)WARM ZONE(Contamination Reduction Zone)COLD ZONE(Support Zone)EQUIPMENTEQUIPMENT AND PERSONNELBASELOCATIONFUNCTIONPIECES# STAFFPER SHIFTMOBETIMEDEPLOYTIMEMobile UnitPERSONNEL DECON CORRIDORCheck-outstationExitDry Decon Unit All Decontamination 1 4 1 hr 1 hrWet Decon Unit GPB, KRU, Alpine Decontamination 1 4 1 hr 1 hrDecon Pits ACS, KRU Decontamination 2 3 initial 1 hr 1 hrPortable Decon Berms All Decontamination 12 for initial setup,and 1 to check andfuel occasionally1 hr 0.5 hrSee Tactic L-2 for additional support equipment.Control boundaries must be established for any spill site to ensure that people are not exposed to the spilled substance:• Exclusion or Hot Zone — Control zone perimeter established by the Safety Officer where pre-site entryand site entry procedures are applied (see Tactics S-1 and S-2)• Contamination Reduction or Warm Zone — Workers shed contaminated clothing; allows for equipmentand personnel decontamination.• Support or Cold Zone — No contamination. Zone has support facilities, staging area, warm-up trailer, andmobile command post.ACS Tech. Manual Vol. 1, 03/12 NOTE: All values given on these pages are for planning purposes only.NOTE: All values given on these pages are for planning purposes only. ACS Tech. Manual Vol. 1, 03/12
Page 1 and 2: Alaska Clean Seas Technical ManualV
Page 3 and 4: ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Page 5 and 6: TACTICTACTICNOTE: “Base Location
Page 7 and 8: SAMPLE TACTICS DESCRIPTIONTactics a
Page 9 and 10: AcronymsAcronymsACACSADECADF&GADNRA
Page 11 and 12: TACTICS LIST (Page 3 of 4)(Page 4 o
Page 13 and 14: TACTIC S-1 Site Entry Procedures (P
Page 15: TACTIC S-3 Identifying Required Per
Page 19 and 20: TACTIC S-6 Decontamination (Page 1
Page 25 and 26: TACTIC S-8 Safety During Operations
Page 27 and 28: TACTIC C-2 Deflection Booming at a
Page 29 and 30: TACTIC C-4 Barriers on Land (Page 1
Page 31 and 32: TACTIC C-6 Underflow Dam (Page 1 of
Page 33 and 34: TACTIC C-8 Deflection Booming in St
Page 35 and 36: TACTIC C-8 Deflection Booming in St
Page 37 and 38: TACTIC C-10 Containment Using Ice R
Page 39 and 40: TACTIC C-12 Trenching Ice to Direct
Page 41 and 42: TACTIC C-14 Exclusion Booming in Op
Page 43 and 44: TACTIC C-16 Anchored W Deflection B
Page 45 and 46: TACTIC C-18 Containing Light Layer
Page 47 and 48: TACTIC R-1 Mechanical Recovery of L
Page 49 and 50: TACTIC R-2 Manual Recovery of LIght
Page 51 and 52: TACTIC R-4 Flushing of Oil on Tundr
Page 53 and 54: TACTIC R-6 Recovery by Direct Sucti
Page 55 and 56: TACTIC R-8 Use of Portable Skimmers
Page 57 and 58: TACTIC R-10 Fairchild Gate Weir Col
Page 59 and 60: TACTIC R-12 Aggressive Breakup in R
Page 61 and 62: TACTIC R-14 Recovery of Oil Under I
Page 63 and 64: TACTIC R-15 Anchored V-Boom to Skim
Page 65 and 66: TACTIC R-17 J-Boom to Skimmer and M
Page 67:
TACTIC R-19 J-Boom to Tank Barge or
Page 70 and 71:
TACTIC R-21 Hot-Water, High-Pressur
Page 72 and 73:
TACTIC R-23 Tank on Trailer (Fuel T
Page 74 and 75:
TACTIC R-25 Freighter Boat with Tan
Page 76 and 77:
TACTIC R-27 Damaged Tank Transfer P
Page 78 and 79:
TACTIC R-29 Ice Mining (Page 1 of 2
Page 80 and 81:
TACTIC R-31 Free Skimming (Page 1 o
Page 82 and 83:
TACTIC R-32B Double Boom-Arm Skimmi
Page 84 and 85:
TACTIC T-1 Delineation of Oiled Sno
Page 86 and 87:
TACTIC T-3 Detection and Delineatio
Page 88 and 89:
TACTIC T-4A Discharge Tracking in I
Page 90 and 91:
TACTIC T-6 Blowout Modeling (Page 1
Page 92 and 93:
TACTIC T-6 Blowout Modeling (Page 5
Page 94 and 95:
TACTIC T-7 Spill Volume Estimation
Page 96 and 97:
Safe Distance in Populated, Flat Te
Page 98 and 99:
TACTIC B-1A In-Situ Burning Plan an
Page 100 and 101:
TACTIC B-3 In-Situ Burning with Hel
Page 102 and 103:
TACTIC B-4 Deployment and Use of Fi
Page 104 and 105:
TACTIC B-6 Burn Residue Recovery (P
Page 106 and 107:
TACTIC DT-1 Dispersant Application
Page 108 and 109:
TACTIC DT-3 Dispersant Application
Page 110 and 111:
TACTIC SH-2 Natural Recovery of an
Page 112 and 113:
TACTIC SH-4 Shoreline Cleanup Using
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
TACTIC SH-10 Shoreline Cleanup Usin
Page 120 and 121:
TACTIC SH-12 Summary of Potential I
Page 122 and 123:
TACTIC W-1A RRT Hazing Checklist (P
Page 124 and 125:
TACTIC W-1A RRT Hazing Checklist (P
Page 126 and 127:
TACTIC W-1B RRT Capture/Transportat
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
TACTIC W-2 Wildlife Hazing Equipmen
Page 134 and 135:
TACTIC W-2B Bird Hazing (Page 1 of
Page 136 and 137:
TACTIC W-4 Salvage of Dead Wildlife
Page 138 and 139:
TACTIC W-6 Identifying and Protecti
Page 140 and 141:
LIQUID WASTETACTIC D-1 Processing R
Page 142 and 143:
TACTIC D-1 Processing Recovered Liq
Page 144 and 145:
TACTIC D-2 Storage and Disposal of
Page 146 and 147:
TACTIC D-3 Disposal of Non-Oily Was
Page 148 and 149:
TACTIC D-4 Stockpiling Oiled Gravel
Page 150 and 151:
TACTIC L-1 Ice Road Construction fo
Page 152 and 153:
TACTIC L-2 Staging Areas (Page 3 of
Page 154 and 155:
TACTIC L-3 Deployment Strategies (P
Page 156 and 157:
TACTIC L-4 Logistical Support (Page
Page 158 and 159:
TACTIC L-5 Communications (Page 3 o
Page 160 and 161:
TACTIC L-5 Communications (Page 7 o
Page 162 and 163:
TACTIC L-6 ACS Response Equipment S
Page 164 and 165:
TACTIC L-6 ACS Response Equipment S
Page 166 and 167:
TACTIC L-7 Realistic Maximum Operat
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
TACTIC L-9 Accessing Contract Resou
Page 174 and 175:
TACTIC L-11 Best Available Technolo
Page 176 and 177:
TACTIC L-11A BAT Analysis: ACS Comm
Page 178 and 179:
TACTIC L-11C BAT Analysis: Wildlife
Page 180 and 181:
TACTIC A-1 Emergency Action Checkli
Page 182 and 183:
TACTIC A-2 Spill Reporting Procedur
Page 184 and 185:
TACTIC A-4 Training Requirements fo
Page 186:
TACTIC A-5 ACS Certifications (Page
show all

(ACS) Technical Manual - Alaska Clean Seas

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?