(ACS) Technical Manual - Alaska Clean Seas

More documents

Recommendations

Info

TACTIC C-15 Intertidal Booming (Page 1 of 2) Intertidal Booming (Page 2 of 2) TACTIC C-15NOTE: “Base Location” is storage location (may change seasonally); “Mobe Time” is time to get it out of storage, prepare it foroperation, and make it ready to travel (concurrent for all equipment); “Deploy Time” is time to make it operational for its intended useat the spill site. These times do not include travel time from base to spill site, which may have multiple components (see Tactic L-3).Shoreline ProjectionCross-SectionEQUIPMENT AND PERSONNELTo determine the approximate length of Shore Seal boom required, multiply 1.1 times the length of shoreline to beprotected. Select vessels and booms according to area, water depth restrictions, and function (see Tactic L-6).Conventional BoomAir ChamberWater ChamberShore Seal BoomShoreEQUIPMENTShore Seal BoomFloating Pump and BlowerBASELOCATIONACS, KRU, MPU,AlpineACS, KRU, MPU,AlpineFUNCTIONOil exclusionPIECES>50 ft# STAFFPER SHIFTMOBETIMEShore Seal inflation 1 1 hr4Work Boat All Boom placement 1 1 hrAnchor System All Anchor boom Variable 1 hr1 hrDEPLOYTIME1.5 hrWater*Recovery crews will perform maintenance.TOTAL STAFF FOR SETUP 4*Shore Seal Boom Cross-SectionOilAir-filledWaterWater-filledSUPPORTSorbents are used in conjunction with Shore Seal boom. Shovels or light excavating equipment help establishonshore anchors. Floats and chains are used in conjunction with offshore anchors.EQUIPMENTAvgas TrailerBASELOCATIONACS, GPB, KRU,Badami, AlpineFUNCTIONPIECES# STAFFPER SHIFTMOBETIMEDEPLOYTIMEAirboat fuel 1 1 initial 1 hr 0.5 hrShore Seal boom is bottom-founded and anchored at tideline and in very shallow water. Sorbent boom would beused at connections to prevent leaching.CAPACITIES FOR PLANNING• One response team can deploy and tend up to 1,000 ft of Shore Seal boom in a 12-hour shift.DEPLOYMENT CONSIDERATIONS AND LIMITATIONS• Shore Seal boom uses water ballast so that it can float free in high tide and seal to the intertidal shore during lowtide. Shore Seal booms also protect shoreline from wave events. Shore Seal boom will adjust to changing waterlevels.• When the boom is grounded, the heavy water ballast seals the boom to the shoreline and prevents oil frommoving along the intertidal zone.ACS Tech. Manual Vol. 1, 03/12 NOTE: All values given on these pages are for planning purposes only.NOTE: All values given on these pages are for planning purposes only. ACS Tech. Manual Vol. 1, 03/12
TACTIC C-16 Anchored W Deflection Boom (Page 1 of 2) Anchored W Deflection Boom (Page 2 of 2) TACTIC C-16NOTE: “Base Location” is storage location (may change seasonally); “Mobe Time” is time to get it out of storage, prepare it foroperation, and make it ready to travel (concurrent for all equipment); “Deploy Time” is time to make it operational for its intended useat the spill site. These times do not include travel time from base to spill site, which may have multiple components (see Tactic L-3).OilDeploySkimming SystemsEQUIPMENT AND PERSONNEL• Initial deployment of a section of boom and setting of anchor points involve one boat with one operator and twocrew members. Select vessels and boom according to area, water depth restrictions, and function (see TacticL-6). Specific personnel requirements depend on the length and type of boom and the nature of the area.EQUIPMENTBASELOCATIONFUNCTIONPIECESBoom All Spill deflection >300 ftWork Boat All Deploy and tend boom 3 for setup2 to maintainAnchor Systems40-lb: All66-lb: ACS# STAFFPER SHIFTMOBETIME1 hr1 hr9 for setup6 to maintainAnchor boom Variable 1 hrDEPLOYTIME6 hrSUPPORTSOURCEWindDeploySkimmingSystem• An aircraft can track oil from above and coordinate the on-water task forces.EQUIPMENTAvgas TrailerBASELOCATIONACS, GPB, KRU,Badami, AlpineFUNCTIONPIECES# STAFFPER SHIFTMOBETIMEDEPLOYTIMEAirboat fuel 1 1 (initial) 1 hr 0.5 hrMechanic Support All Support equipment 1 1 1 hr 0.5 hrFuel Truck All Fuel 1 Once per shift 1 hr 0.5 hrLengths of deflection boom are anchored in a “W” configuration. Boom sections up to 1,000 feet long are orientedat an angle to the wind and to each other. Oil encountering the center “V” of the boom becomes more concentratedat the downwind end of the configuration and is recovered with a positioned skimming system. Oil is collected fromthe pockets of the “V”s with a vessel with a skimmer and mini-barge.CAPACITIES FOR PLANNING• Swath width varies with currents, wind, and the total length of booms.See Tactic R-30 for boom configuration for subsea pipeline leak.DEPLOYMENT CONSIDERATIONS AND LIMITATIONS• Check anchor points frequently and reposition them as necessary by lifting the crown line.• Change the length and position of the boom as conditions change.• See recovery tactics for information on recovery equipment used with this tactic.ACS Tech. Manual Vol. 1, 03/12 NOTE: All values given on these pages are for planning purposes only.NOTE: All values given on these pages are for planning purposes only. ACS Tech. Manual Vol. 1, 03/12
Page 1 and 2: Alaska Clean Seas Technical ManualV
Page 3 and 4: ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Page 5 and 6: TACTICTACTICNOTE: “Base Location
Page 7 and 8: SAMPLE TACTICS DESCRIPTIONTactics a
Page 9 and 10: AcronymsAcronymsACACSADECADF&GADNRA
Page 11 and 12: TACTICS LIST (Page 3 of 4)(Page 4 o
Page 13 and 14: TACTIC S-1 Site Entry Procedures (P
Page 15 and 16: TACTIC S-3 Identifying Required Per
Page 17 and 18: TACTIC S-4 Site Layout (Page 1 of 2
Page 19 and 20: TACTIC S-6 Decontamination (Page 1
Page 25 and 26: TACTIC S-8 Safety During Operations
Page 27 and 28: TACTIC C-2 Deflection Booming at a
Page 29 and 30: TACTIC C-4 Barriers on Land (Page 1
Page 31 and 32: TACTIC C-6 Underflow Dam (Page 1 of
Page 33 and 34: TACTIC C-8 Deflection Booming in St
Page 35 and 36: TACTIC C-8 Deflection Booming in St
Page 37 and 38: TACTIC C-10 Containment Using Ice R
Page 39 and 40: TACTIC C-12 Trenching Ice to Direct
Page 41: TACTIC C-14 Exclusion Booming in Op
Page 45 and 46: TACTIC C-18 Containing Light Layer
Page 47 and 48: TACTIC R-1 Mechanical Recovery of L
Page 49 and 50: TACTIC R-2 Manual Recovery of LIght
Page 51 and 52: TACTIC R-4 Flushing of Oil on Tundr
Page 53 and 54: TACTIC R-6 Recovery by Direct Sucti
Page 55 and 56: TACTIC R-8 Use of Portable Skimmers
Page 57 and 58: TACTIC R-10 Fairchild Gate Weir Col
Page 59 and 60: TACTIC R-12 Aggressive Breakup in R
Page 61 and 62: TACTIC R-14 Recovery of Oil Under I
Page 63 and 64: TACTIC R-15 Anchored V-Boom to Skim
Page 65 and 66: TACTIC R-17 J-Boom to Skimmer and M
Page 67: TACTIC R-19 J-Boom to Tank Barge or
Page 70 and 71: TACTIC R-21 Hot-Water, High-Pressur
Page 72 and 73: TACTIC R-23 Tank on Trailer (Fuel T
Page 74 and 75: TACTIC R-25 Freighter Boat with Tan
Page 76 and 77: TACTIC R-27 Damaged Tank Transfer P
Page 78 and 79: TACTIC R-29 Ice Mining (Page 1 of 2
Page 80 and 81: TACTIC R-31 Free Skimming (Page 1 o
Page 82 and 83: TACTIC R-32B Double Boom-Arm Skimmi
Page 84 and 85: TACTIC T-1 Delineation of Oiled Sno
Page 86 and 87: TACTIC T-3 Detection and Delineatio
Page 88 and 89: TACTIC T-4A Discharge Tracking in I
Page 90 and 91: TACTIC T-6 Blowout Modeling (Page 1
Page 92 and 93:
TACTIC T-6 Blowout Modeling (Page 5
Page 94 and 95:
TACTIC T-7 Spill Volume Estimation
Page 96 and 97:
Safe Distance in Populated, Flat Te
Page 98 and 99:
TACTIC B-1A In-Situ Burning Plan an
Page 100 and 101:
TACTIC B-3 In-Situ Burning with Hel
Page 102 and 103:
TACTIC B-4 Deployment and Use of Fi
Page 104 and 105:
TACTIC B-6 Burn Residue Recovery (P
Page 106 and 107:
TACTIC DT-1 Dispersant Application
Page 108 and 109:
TACTIC DT-3 Dispersant Application
Page 110 and 111:
TACTIC SH-2 Natural Recovery of an
Page 112 and 113:
TACTIC SH-4 Shoreline Cleanup Using
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
TACTIC SH-10 Shoreline Cleanup Usin
Page 120 and 121:
TACTIC SH-12 Summary of Potential I
Page 122 and 123:
TACTIC W-1A RRT Hazing Checklist (P
Page 124 and 125:
TACTIC W-1A RRT Hazing Checklist (P
Page 126 and 127:
TACTIC W-1B RRT Capture/Transportat
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
TACTIC W-2 Wildlife Hazing Equipmen
Page 134 and 135:
TACTIC W-2B Bird Hazing (Page 1 of
Page 136 and 137:
TACTIC W-4 Salvage of Dead Wildlife
Page 138 and 139:
TACTIC W-6 Identifying and Protecti
Page 140 and 141:
LIQUID WASTETACTIC D-1 Processing R
Page 142 and 143:
TACTIC D-1 Processing Recovered Liq
Page 144 and 145:
TACTIC D-2 Storage and Disposal of
Page 146 and 147:
TACTIC D-3 Disposal of Non-Oily Was
Page 148 and 149:
TACTIC D-4 Stockpiling Oiled Gravel
Page 150 and 151:
TACTIC L-1 Ice Road Construction fo
Page 152 and 153:
TACTIC L-2 Staging Areas (Page 3 of
Page 154 and 155:
TACTIC L-3 Deployment Strategies (P
Page 156 and 157:
TACTIC L-4 Logistical Support (Page
Page 158 and 159:
TACTIC L-5 Communications (Page 3 o
Page 160 and 161:
TACTIC L-5 Communications (Page 7 o
Page 162 and 163:
TACTIC L-6 ACS Response Equipment S
Page 164 and 165:
TACTIC L-6 ACS Response Equipment S
Page 166 and 167:
TACTIC L-7 Realistic Maximum Operat
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
TACTIC L-9 Accessing Contract Resou
Page 174 and 175:
TACTIC L-11 Best Available Technolo
Page 176 and 177:
TACTIC L-11A BAT Analysis: ACS Comm
Page 178 and 179:
TACTIC L-11C BAT Analysis: Wildlife
Page 180 and 181:
TACTIC A-1 Emergency Action Checkli
Page 182 and 183:
TACTIC A-2 Spill Reporting Procedur
Page 184 and 185:
TACTIC A-4 Training Requirements fo
Page 186:
TACTIC A-5 ACS Certifications (Page
show all

(ACS) Technical Manual - Alaska Clean Seas

Create successful ePaper yourself

Delete template?

Save as template?