MDX-40A Setup Guide - Support

More documents

Recommendations

Info

<strong>MDX</strong>-<strong>40A</strong> Setting Origin Points Place Z0 sensor above material and connect sensor cable to thesensor and Z0 connector on the back left side of machine. Move tool so that it is right above the sensor about .250”.NOTES:Click on “Set Z origin i using sensor” then click on Detect t tobegin tool detection.
Page 1 and 2: MDX-40A Setup
Page 3 and 4: MDX-40A Power OnTurning MDX-40A onN
Page 5 and 6: MDX-40A Driver InstallDriver Instal
Page 7 and 8: Setup Basics - Installing Tool• I
Page 9: MDX-40A Adding MaterialAffix materi
Page 13 and 14: ZCL-40A Rotary AxisThe ZCL-40A allo
Page 15 and 16: ZCL-40A SetupRemove 8 screws andrem
Page 17 and 18: ZCL-40A SetupMake sure power to mac
Page 19 and 20: ZCL-40A Setup• Install Live cente
Page 21 and 22: ZCL-40A Setup• Tighten knob to se
Page 23 and 24: ZCL-40A Setup• You will be remind
Page 25 and 26: ZCL-40A Material Setup• Install m
Page 27 and 28: ZCL-40A Material Setup• Turn tail
Page 29 and 30: ZCL-40A Material Setup• Turn tail
Page 31 and 32: ZCL-40A Material Setup• Once fini
Page 33: ZCL-40A Origin Setting• The MDX-4

MDX-40A Setup Guide - Support

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?