MDX-40A Setup Guide - Support

More documents

Recommendations

Info

Setup Basics – Installing Tool• To tighten the collet, use both spanners to tighten the collet.• TIP: Use the 17mm wrench in the left hand and 10mmwrench in the right hand. Pull the wrenches away totighten the collet. Tighten to about 3.2 N-m of force.NOTES:• TIP: To loosen the collet, again with the 17mm wrench inthe left hand and 10mm in the right hand, pull the wrenchestowards each other. Support toolto prevent the tool from dropping.
MDX-40A Adding MaterialAffix material to MDX-40A table using either AS-10sheets or double sided carpet tape (heavy traffic type)NOTES:•Double sided carpet tape(Heavy traffic variety) can bepurchased at local hardwarestore such as Home Depot andAce Hardware.•Best tape is fabric based tapenot foam or fiberglass typetape as it is easily removedfrom the table.
Page 1 and 2: MDX-40A Setup
Page 3 and 4: MDX-40A Power OnTurning MDX-40A onN
Page 5 and 6: MDX-40A Driver InstallDriver Instal
Page 7: Setup Basics - Installing Tool• I
Page 12 and 13: MDX-40AThe MDX-40A is now ready to
Page 14 and 15: What’s IncludedAll items included
Page 16 and 17: ZCL-40A SetupMake sure that the scr
Page 18 and 19: ZCL-40A SetupWhen you turn the ZCL-
Page 20 and 21: ZCL-40A SetupSetting Y Origin• In
Page 22 and 23: ZCL-40A Setup• Click on Detect Ji
Page 24 and 25: ZCL-40A Setup• Remove Y-Origin se
Page 26 and 27: ZCL-40A Material Setup• Click on
Page 28 and 29: ZCL-40A Material Setup• Remove ce
Page 30 and 31: ZCL-40A Material Setup• Install t
Page 32 and 33: ZCL-40A Material Setup• You CAM s

MDX-40A Setup Guide - Support

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?