MULTI S400 - Seatronic

More documents

Recommendations

Info

Alimentation 12V power supply 12 volts + -menuBusme nuBuzzer ouBuzzer lampe or light+ -- +Entrée NMEA NMEA input+-Sortie NMEA NMEAoutputCapteur Depth sondeur transducerCapteur Speed speedo transducerInstallation and Operation Manual <strong>S400</strong> series 21
4. TroubleshootingThis troubleshooting guide assumes that you have read and understood this manual.It is possible in many cases to solve difficulties without the need for the after-salesservice. Please read this chapter carefully before contacting your AdvanSea retailer.1. The unit will not power on: Fuse melted or circuit breaker triggered. Voltage too low Power cable disconnected or damaged.2. Wrong or incoherent speed reading: Calibration incorrect Speed sensor cable disconnected or damaged Speed/temperature sensor damaged. Check thepaddlewheel. Incorrect mounting or sensor not sufficiently immersed.Review the installation. Electrical interference. Review the installation.3. Wrong or incoherent depth reading: The unit cannot detect the sea bottom momentarily,because the depth is too high or too low, due to lack ofwater clarity, reverse manoeuvring or rough seas. Sensor cable disconnected or damaged. Dirty or damaged sensor. Check that the sensor is notcovered with too thick a coat of paint. Sensor incorrectly mounted or not sufficiently immersed. Ultrasound signal interference from another sensor. Electrical interference. Review the installation.It is recommended to do a test with another working sensor (hold itunder water near the boat) to check if the sounder and the on-boardsensor are working correctly.4. Wrong temperature reading: Calibration incorrect. Speed/temperature sensor cable damaged.5. SIMU flashing on the screen, with incoherent readingsdisplayed. Unit in simulation mode (see 2.5.7).If the problems continue, we recommend you contact your advanSea retailer or ourcustomer support department. All contacts can be found at www.advansea.com.Installation and Operation Manual <strong>S400</strong> series 22
Page 2 and 3: WarningS400 advanSea instruments co
Page 4 and 5: 3. Installation3.1. NMEA 0183 inter
Page 6 and 7: To do so, it is supplied with 3 con
Page 8 and 9: 2 General operation2.1. Powering on
Page 10 and 11: 2.2.3. Selecting units of measureme
Page 12 and 13: An alarm can be cancelled and inhib
Page 14 and 15: 2.4.3. Calibrating the water temper
Page 16 and 17: 2.4.9. Resetting data in the memory
Page 18 and 19: System limitation:For complex insta
Page 20 and 21: 3.2. Mounting and connections3.2.1.
Page 24 and 25: FRANCE & SWITZERLANDPlastimo France

MULTI S400 - Seatronic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?