SIMRAD GD10P - IR GAS DETECTOR - ICEWeb

174. MAINTENANCENOTE: The GD10P has no user adjustable parts. It is notrecommended to open the GD10P, as this will change the internalatmosphere, and the initial calibration could be affected.NOTE: Opening the GD10P voids all warrantee offered at time of sale.4.1 GeneralThe GD10P has been designed to require a minimum of maintenance.The only necessary maintenance is to inspect visually that theWeather Protection is not clogged in heavily contaminated areas.4.2 Cleaning of optical window and mirrorIf the optical window and mirror have to be cleaned, use a soft, cleantissue to rub off the contamination. The window and mirror are madeof sapphire, which is highly resistant to scratching. Make sure that thewhole optical surface is clean.NOTE: For difficult contaminants the mirror and lens can be cleanedwith an equal-part mixture of isopropyl alcohol and water. Do notperform any testing of the sensor before this solution has dried andresidues have been wiped away4.3 Function testIn order to perform function test of the detector, a test gas can beapplied through a 6 mm test nozzle on the front of the WeatherProtection housing. Read the effect on the sensor output signal orthrough the gas detection system.The GD10P has been designed for long-term stability, and in order toretain the high reliability of the GD10P it is only necessary to monitorthe detector's zero point and error messages from the detector. Toavoid inhibiting the response time of the detector, the WeatherProtection has been designed as open as possible to facilitate gasflow-through. Therefore, it is difficult to fill the gas measuring pathcompletely with test gas, especially in windy weather.A function test of the GD10P can be performed as follows:• If there is no air movement, a test gas flow of minimum 4litres/minute will give approximately the same value as the testgas.