CEBO-LC

Recommendations

Info

1. Keep voltages on Trigger I/O below Maximum Input Voltage to prevent CEBO-LC from damage. This is also true, if CEBO-LC is unpowered. 2. Protective circuit of TRG terminal uses lower resistor value than normal Digtial I/O. 3. Keep the total number of edges below this limit, to avoid missing edges. 4. Input frame consisting of Analog Input 0. Specifications - Counter Parameter Condition Min Typical Max Units Low Level Input Voltage -0,3 0,8 volts High Level Input Voltage 2 5,8 volts Maximum Input Voltage (1) -10 10 volts Input Total Edge Rate (2) Without reading (3) 300.000 edges/s Continuously polling Counter value 35.000 edges/s Mutli Frame DAQ @ 1 kHz (4) 25.000 edges/s Mutli Frame DAQ @ 25 kHz (4) 5.000 edges/s 1. Keep voltages on Trigger I/O below Maximum Input Voltage to prevent CEBO-LC from damage. This is also true, if CEBO-LC is unpowered. 2. Keep the total number of edges below the Max limit, to avoid missing edges. 3. Counter value is only checked, after counting events have been disabled. 4. Input frame consisting of Analog Input 0 & counter value. Specifications - Constant Current Source 200µA Parameter Condition Min Typical Max Units Absolute Accuracy(1) ~25°C; RSpecifications - Constant Current Source 10µA Parameter Condition Min Typical Max Units Absolute Accuracy(1) ~25°C; R(1) Compared to calibration data stored in flash.Specifications - 5 Volt Output (1) A resettable 100mA fuse prevents overcurrent on 5V Power Outputs. Specifications - Vcc/Vss-Output 50/51
Parameter Conditions Min Typical Max Units Typical Voltage No-load ±12 volts @ 2,5mA ±??? volts Maximum Current ??? mA 51/51
Page 1 and 2: CEBO-LC www.cesys.com/uploads/manua
Page 3 and 4: • Measuring voltages and resistan
Page 5 and 6: 5/51
Page 7 and 8: Screw terminal A selection of CEBO-
Page 9 and 10: Expansion Connector (DB25) Addition
Page 11 and 12: USB Interface CEBO-LC is a full-spe
Page 13 and 14: Analog Inputs Features: • 8 Singl
Page 15 and 16: value. RMS and Effective data are c
Page 17 and 18: Specifications - Digital Input Para
Page 19 and 20: Alternating Mode In alternating mod
Page 21 and 22: Counter CEBO-LC has an external cou
Page 23 and 24: Constant-current sources CEBO-LC ha
Page 25 and 26: CEBO-LC/OEM CEBO-LC is also availab
Page 27 and 28: normal firmware, these are used to
Page 29 and 30: Data acquisition modes Some measure
Page 31 and 32: Frames CEBO-LC has various sources
Page 33 and 34: Interchannel delay In general, sett
Page 35 and 36: Intention The idea behind this feat
Page 37 and 38: 6xSingleEnded 14.000 frames per sec
Page 39 and 40: Calibration CEBO devices come facto
Page 41 and 42: Application Software The generic So
Page 43 and 44: At the "Measure"-tab you can • en
Page 45 and 46: LabView - Demo 2 This is a small to
Page 47 and 48: • API version whitch is used •
Page 49: Specifications - Digital Input Para

CEBO-LC

Create successful ePaper yourself

Delete template?

Save as template?