EN.33.C.14_LK Wireless Room Control Cq 1, 4 & 6 ... - LK Systems AB

Assembly instructions | LK Wireless Room Control Cq 1, 4 & 6 (NO)Cq 4 and Cq 6 Control UnitFor the Cq 4 and Cq 6 Receiver Unit, a maximumof 4 actuators can be connected to each channel.The circuit diagram shows that all channels in Cq4, and 2 channels in Cq 6, have double terminalboards, a or c respectively, for connecting the actuators.Cq4 and Cq6 receiver units can operate amaximum of 16 actuators.When connecting two or more actuators to thesame channel, the connections must be only tothe double circuit boards.channel 1 channel 2 channel 3 channel 4Supply AC 24VLK TransformerMMains AC 230V29NCircuit diagram Cq 1, (M = Actuator).LK Transformer 230/24 V ACA transformer 60 VA for 24V AC supply is connectedin accordance with the circuit diagram foreach receiver unit.MainsAC 230VSupply AC 24VLK TransformerCircuit diagram Cq 4, (M = actuator).channel 1 channel 2 channel 3 channel 4 channel 5 channel 6MainsAC 230VSupply AC 24VLK TransformerCircuit diagram Cq 6, (M = actuator).Cq 1 Receiver UnitCq 1 Receiver Unit differs from the other units asup to eight actuators can be connected.230V mains voltage connection• Connect the receiver unit and the transformerto the mains.• Check the primary and secondary voltage.• Reassemble the protection box on the receiverunit before Memorizing/Start-up.Up to two actuators can be connected direct toCq1. However, if necessary, it is possible to connectup to eight actuators to Cq1 by using an externalwiring/junction box. In both cases the actuatorsare connected parrallel to each other andin line between terminal 9 and the LK Transformer.EN.33.C.14.2