2nd Edition 2nd Edition - Aspen Electronics

Programmable DC Power SuppliesDLM 600 Series, 600W• High Power Density: 600W in 1U High, Half Rack Width.• Remote Voltage Sense.• Optional LAN, GPIB & RS-232 Interfaces.• Five Year WarrantyPower(Watts)Current(ADC)Voltage(Vdc)Models DLM 5-75DLM 8-75DLM 10-60DLM 20-30DLM 40-15DLM 60-10DLM 80-7.5DLM 150-4DLM 300-20 ~ 50 ~ 80 ~ 100 ~ 200 ~ 400 ~ 600 ~ 800 ~ 1500 ~ 3000 ~ 750 ~ 750 ~ 600 ~ 300 ~ 150 ~ 100 ~ 7.50 ~ 40 ~ 2375600600600600600600600600COMMON SPECIFICATIONSOutputInputCommonLine RegulationLoad RegulationTransient ResponseStabilityEfficiencyTemperature CoefficientVoltage & FrequencyCurrentConnectorPower FactorCoolingFront Panel ControlsDisplays & IndicatorsRemote ProgrammingMaster/SlaveSoftwareDimensions & WeightVoltage: 0.005% of Vmax + 2mVCurrent: 0.01% of Imax + 2mAVoltage: 0.005% of Vmax + 2mVCurrent: 0.02% of Imax + 5mA500μs to Steady-state Output Voltage for 50 ~ 100% Load Change±0.05% of Maximum Voltage or Current (over 8 Hours After 30Minutes Warm-up at Fixed liNe, Load and Temperature)84% Typical at Maximum Output Power(82% for DLM-5-75 & DLM-875)0.02%/°C of Maximum Output Voltage.0.03%/°C of Maximum Output Current.90 ~ 132 Vac or 180 ~ 264 Vac, Auto-ranging, 47 ~ 63Hz,Single Phase, 2-Wire Plus Ground.11A Maximum at 115 Vac, 6A Maximum at 230 VacIEC320 with Detachable Line Cord>0.6, Typical @ Full LoadVariable Speed Fans with Over Temperature Protection. Air Intakeis From the Front and Sides with Exhaust at Rear and Sides toAchieve Maximum Rack Mount DensityKnobs to Control Output Settings, Outputs On/Off Switch andLocal/Remote Switch. Voltage/Current and Over Voltage PushButtons Allow Preview of Programmed SettingsTwo 3½ digit LED Displays, One for Output Voltage and OVP, theOther for Current. LEDs to Indicate Voltage/Current Mode, OVP,Fault, Remote & Output on.Voltage, Current (0 ~ 100%) and OVP (5 ~ 110%) of Full Scale canbe Programmed by Selectable 0 ~ 5 Vdc, 0 ~ 10 Vdc or 0 ~ 5kΩUp to 4 Units of the Same Model Can be Connected in Parallel.Multiple Units of the Same Model Can be Connected inSeries Within Limitations.LabView ® Driver Can be Downloaded Free of Charge44mm (H) x 216mm (W) x 432mm (D), 4.4kgDLM ModelM9GM130M6M13M51AM85DLMP1DLMRKORDERING INFORMATIONSelect Model from the Above Table with Desired Voltage & Current Output.GPIB & RS-232 Interfaces (May not be Combined with M51A or M85).LAN & RS-232 Interfaces.Disconnect & Polarity Reversal Relays, 10V ~ 300V Models Only, Requires Remote Control Option.Locking Shafts for Front Panel Potentiometers.Optically Isolated Analogue Interface (May not be Combined with M9G or M85).Multi-Channel Slave Interface (May not be Combined with M9G or M51A).Paralleling Cable (One Cable per Slave Unit).Rack Mount Kit for Single DLM with Filler Panel or for Two Models Mounted Side-by-Side.80Tel: +44 (0)20 8868 1311 Fax: +44 (0)20 8866 65961-3 Kildare Close, Eastcote, Ruislip, Middlesex HA4 9UR