SAFETY DATA SHEET NITOSEAL PU12 ACCELERATOR

REVISION DATE 25/07/2010NITOSEAL PU12 ACCELERATOR6 ACCIDENTAL RELEASE MEASURESSPILL CLEAN UP METHODSWear necessary protective equipment. Stop leak if possible without risk. Absorb in vermiculite, dry sand or earth and place intocontainers. Do not let washing down water contaminate ponds or waterways.7 HANDLING AND STORAGESTORAGE PRECAUTIONSStore in tightly closed original container in a dry, cool and well-ventilated place. Keep in original container.STORAGE CLASSCorrosive storage.8 EXPOSURE CONTROLS/PERSONAL PROTECTIONNameSTDTWA - 8 HrsSTEL - 15 MinNotesCALCIUM CARBONATE (STEARATE COATED)WEL10 mg/m3Inhal. Dust4 mg/m3Resp. DustWEL = Workplace Exposure Limit.PROTECTIVE EQUIPMENTENGINEERING MEASURESProvide adequate general and local exhaust ventilation.RESPIRATORY EQUIPMENTNo specific recommendation made, but respiratory protection must be used if the general level exceeds the recommended occupationalexposure limit.HAND PROTECTIONUse protective gloves made of: Nitrile. Viton rubber (fluor rubber). Polyvinylidene chloride/Polyethylene (PVD/PE).EYE PROTECTIONWear approved chemical safety goggles where eye exposure is reasonably probable.OTHER PROTECTIONWear appropriate clothing to prevent skin contamination or freezing. Provide eyewash station.HYGIENE MEASURESWash at the end of each work shift and before eating, smoking and using the toilet. Wash promptly with soap & water if skin becomescontaminated. Promptly remove any clothing that becomes wet.9 PHYSICAL AND CHEMICAL PROPERTIESAPPEARANCECOLOURODOURPasteGreyAmine. Musty (mouldy).BOILING POINT (°C)RELATIVE DENSITY 1.46 20VAPOUR PRESSURE> 200 for volatile components.0.04 kPapH-VALUE, CONC. SOLUTION approx. 12.0FLASH POINT (°C) 131AUTO IGNITIONTEMPERATURE (°C)> 40010 STABILITY AND REACTIVITYSTABILITYStable under normal temperature conditions.2 / 5