Manual - Pine Tree Stove Shoppe

288.5 GLASS REPLACEMENT! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.56.2A. When the appliance is cool, open thedoor and place the door frame downcareful not to scratch the paint.B. Remove the screws and bracketsholding the glass in place. Remove allbroken glass.C. Wrap the edges of the new glass witha U-shaped strip of fiberglass gasket,covering 1/4” on each side.D. Place the glass with the fiberglassgasket in position and replace thebrackets and screws. When finished,you should be able to move the glassslightly, horizontally and vertically.U-SHAPEDGLASSGASKET½” ROPEDOORGASKETNOTE: For replacement glass, size, thickness and specifications see “REPLACEMENTS” section.8.6 GASKET REPLACEMENTAt the end of each burning season inspect the shield and gasket below the manifold for warping or deterioration.Replace if necessary. Both are held to the manifold with machine screws. The shield and the 1/8” fi brecloth gasket are available from your Wolf Steel Ltd. dealer. At this time also check that the door gasket is notworn or loose. Replace with 1/2” high density fi breglass rope if necessary.The airwash gasket and shield above the door should also be inspected and replaced if deterioratedNOTE: Do not operate appliance if the manifold shield or fibre baffle is deteriorated or missing.W415-0762 / B / 11.12.10