Instruction Manual - Kellyco Metal Detectors

More documents

Recommendations

Info

avoid going over more than one target at a time. This will allow you to identifyeach one and determine if it is worth recovering.If the trash in an area is so much that you are getting numerous choppy or nonrepeatablesignals, you can improve performance of the detector by slowing yoursweep speed down or reducing the Sensitivity level.Sweep the search coil carefully, especially when using around rocks and buildingfoundations. Avoid hitting the search coil against hard, solid objects and surfaces.Keep your search coil slightly off of the ground during the sweep, especially whenusing in gravel or hard, rocky dirt.Care & MaintenanceYour Treasure Commander TC2X has been built to last but proper care and maintenancewill ensure you receive years of trouble free operation. It is recommended that youobserve the following tips.Keep it Clean - Take a few minutes after each use to remove dirt and dust. Wipethe case clean. Wash the loop, especially if it has been dipped in saltwater.15
Keep it Cool - Never keep your detector in an extremely hot environment such asthe trunk of your vehicle in the summer for extended periods of time. Damage tothe electronics and the LCD display screen can occur.Keep it Safe - Never transport your detector in a way that it can be subjected tosudden shock or dropped. Cushion the detector with a blanket or use a carryingcase that can be purchased to carry the detector and accessories.Protect the Electronics - A plastic bag placed over the LCD control pod will keeprain from reaching the electronics or at an ocean beach, will help protect thedetector from blowing sand and prevent corrosion from the salt air. Remember,the coil is waterproof but the electronics are not!Storage - When storing your detector for more than a month, remove the batteriesto prevent them from leaking and damaging the electronics.TroubleshootingPROBLEMPOSSIBLE SOLUTION(S)The detector won't turn ON Ensure the batteries are new or chargedThere is no sound Check that the batteries are installed properly Check that all connections are secure If using headphones, unplug them to check forsound from the internal speaker (headphones maybe defective)The detector operates erratically Check that all connections are secure Lower the Sensitivity level Try searching in a different location as electricalinterference at the current site may be causing theerratic operation. This includes high-voltage powerlines, electric transformers and even undergroundcables and pet containment fencesLCD indication does not lock onMultiple tones are produced whenthe coil passes over a spot Multiple targets may be present - move the coilslowly at different angles in order to seperate themfrom one another The Sensitivity may be set too high for theconditions at the search area, reduce the settingand resweep the area16
Page 1: SiRobertsonSignatureEditionTREASURE
Page 4 and 5: CONGRATULATIONS!Your new Treasure C
Page 8 and 9: Understanding the LCD DisplayThe LC
Page 10 and 11: value before plugging the headphone
Page 12 and 13: Operating ModesThe Treasure Command
Page 14 and 15: Identifying Targets Before You DigT
Page 16 and 17: Let's Find SomethingSo you have spe
Page 20 and 21: Treasure Commander TC2X Specificati
Page 22 and 23: LEARNEVERYTHINGABOUTMETALDETECTINGA
Page 24: Available From:Visit us at: www.kel

Instruction Manual - Kellyco Metal Detectors

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?