Operating Instructions - VEGACAP 67 with two-wire output - Insatech

More documents

Recommendations

Info

Connecting to power supplyI/mA20,5101< 2,31,5 3 4,5 t/sFig. 12: Start-up reaction1 Measured value20 VEGACAP 67 - with two-wire output31317-EN-060223
Set up6 Set up6.1 GeneralThe numbers in brackets refer to the following illustrations.Function/ConfigurationOn the electronics module you will find the following indicatingand adjustment elements:llDIL switch for measuring range selectionControl lampNote:As a rule, always set the mode with the mode switch of thesignal conditioning instrument before starting setup VEGACAP67. The switching output will change if you set the mode switchafterwards. This could possibly trigger connected downstreamdevices.6.2 Adjustment elements413231317-EN-060223Fig. 13: Oscillator - two-wire output1 DIL switch for measuring range selection2 Ground terminal3 Terminals4 Control lampA failure can be displayed when the housing is closed (onlyplastic housing), see "Function chart".VEGACAP 67 - with two-wire output 21
Page 3: Contents8 Dismounting8.1 Dismountin
Page 6 and 7: For your safety2.6 Safety informati
Page 8 and 9: Product description3 Product descri
Page 10 and 11: Product descriptionTypical applicat
Page 13 and 14: Mounting4.2 Mounting informationAgi
Page 15 and 16: d6dMounting123Fig. 6: Filling in th
Page 17 and 18: Connecting to power supply3 Remove
Page 19: Connecting to power supplyThe wirin
Page 23 and 24: Maintenance and fault rectification
Page 25 and 26: Maintenance and fault rectification
Page 27 and 28: Dismounting8 Dismounting8.1 Dismoun
Page 29 and 30: SupplementOutput variableOutputTwo-
Page 31 and 32: SupplementSupply voltageSupply volt
Page 33 and 34: SupplementSW46242mm(9 17/32")ø 38m
Page 35 and 36: Supplement31317-EN-060223VEGACAP 67

Operating Instructions - VEGACAP 67 with two-wire output - Insatech

Create successful ePaper yourself

Delete template?

Save as template?